Routing

This machine is giving me hard time. The problem with it is that it keeps on rebooting. I have tried to even load another IOS. But it is not working out. It is bringing this output......========= Dump bp = 2C66478 ====================== 2C66378: 0 0 ...

Dear all,While trying to apply some policing, i found 2 ways:. Via a policy-map and Police command. Via rate-limit command.I wanted to understand both concepts and the main difference between using any of them; when to use what ...One hint i got is t...

Dear All,I have two routers 7500 with 4 E1 leased lines and one E3 link.I want the voice vlan to go through the 4E1 links only(dedicated links)I configured :----------------On the router at the first site(gateway to the voice vlan)1)Extended IP acces...

I am trying to setup two 4503 switches with HSRP and 10 vlans (5 on each switch).Can you please help me out how to configure this thing up.Thanks

Hi All! PS;Have a look to these output when i try to format the PC CARD On slot0: Console> (enable) format slot0: All sectors will be erased, proceed (y/n) [n]? y Enter volume id (up to 31 characters): Unknown device mfg id (ffffffff.ffffffff.fffffff...

Hello there,i hae 2611XM router and 3750 switch that they are having problem and giving error upon booting.i've attached the errors in the file.please adviceregardsFady

Dear all,I would like to use autoinstall for download the router config from tftp server on another subnet. What is the initial config on the router (e.g. ip address and etc).Thanks.

Anyone have any experience in configuring G.703 multiflex forVoice/WAN? Bear with as this is my first time configuring an E1 G.703multiflex trunk. This will be an international link between 2 countries.My questions are what are the information do I n...

I try to configure a vpn between a pix and router 1710, but i have some error message. Error on pix:QM FSM error (P2 struct &0x18893c0, mess id 0x79263e2d)! [IKEv1] Removing peer from correlator table failed, no match!Show output:BALIPIX001# show cry...

I have a Dailer interface with two BRIs that belong to it. I use the BRIs to backup a frame relay circuit. I have to support up to 256k of bandwidth so i needed four bearer channels. I recently had a problem with the ISDN line that is BRI1/1. I n...

Hi,I have a cisco 1721 router along with an ADSL WIC (and ADSL line), which work fine.When one of the LAN user sends through ftp a large file to an external server, it renders every over external access sluggish (ssh, telnet, dns and even web browsin...

what configuration in the router would let the following display when you run "show running-config" ?!! Last configuration change at 01:12:23 UTC Thu Jun 15 2006! NVRAM config last updated at 16:35:55 UTC Wed Jun 14 2006!Thanks in advance.

I need a router recommendation for the following (I tried cisco's recommendation tool but it did not work?).8-10 Servers providing web hosting (www/email) services will be co-located.The datacenter is providing a 100Mbit Cat5e network drop.We need a ...