Routing

Can I configure a router of satellite site of a remote site that has a point-to-point connection with it, to join to the main DMVPN domain?

Hi alliam designing some network in my site, before that i want ask you some question about decreasing or hiding hopsmy network looks like belowInternet + +Core Router + +Switch with VLAN + + +Router with QOS / Firewall + +Customer edge Rout...

hi,how can we erease the flash memory in rommon mode, for new ios.Thanks

I have a configuration where I am doing BGP peering two different service providers and using HSRP to control outbound failover. One of the service providers (SAVVIS) recently installed two additional T1 interfaces into my router that connects me to...

Hii want upload the IOS of As5300 through Xmodem, but getting errorat HyperTerminal that "remote system is not responding" i have same baud rate on Pc a well as on As5300. and on As5300"mage size exceeds free flash space" I have tried to eraes flash ...

I have a Cisco 2600 series router in my lab...It's a modular router...Right now I have only 1 ethernet port on it (which is on board) I want to increase the number of ethernet ports. Probably I would be going with a expansion card for ethernet.Could ...

Can some one recommend an internet facing device that could provide the following.Qos and deep packet inspection filtering.I'm not looking for a firewall piece of equipment just a dedicated appliance that internet traffic flows through that is specif...

Hi, in my Set up i have a 3620 Cisco router.8 branch offices are connected to this router.and i have 5 Vlans are connected to this, i mean using subinterfaces in Fa0/0.Vlan Users are working fine there is no problem at all.but if i see the wan interf...

I setup my router to log to a server using the command 'logging 10.87.183.20'. Where is that log located once it is on the server?

Hi All,I configured the PE and the CE as follows, but i got a lot of packet loss and a very high delay, any comments ?CE:! interface Loopback13 ip address 13.13.13.2 255.255.255.252!interface Virtual-Template1 bandwidth 2048 ip unnumbered Loo...

Hi I upgraded the Cisco ISR 2821 with IOS c2800nm-advsecurityk9-mz.124-5. My old image is c2800nm-advsecurityk9-mz.124-3a After the upgrade, I reloaded the system. After that, router is not booting up. I see the message like below:System Bootstrap, ...

Below are two different MLPPP configurations. One uses a virtual-template with ip unnumbered and the other a multilink interface with /30's. For bonding multiple T1's together from the CE to PE, what is the best method? In order to enable Qos, is the...

HiI have two location`s with 2801 and both sides have 2 isp connections to internet and site-to-site VPN connection on both the links and both locations, each link should be load balanced and act as failover in case one goes down.The links are 2 Mbps...