Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

crash info:C2950 Software (C2950-I6Q4L2-M), Version 12.1(14)EA1a, RELEASE SOFTWARE (fc1)Compiled Tue 02-Sep-03 03:33 by antoninoSignal = 10, Code = 0x8, Uptime 28w0dr0: 00000000, AT: 00000000, v0: 00000000, v1: 80D581C0a0: 00000006, a1: 00000000, a2:...

Resolved! help with ip route

Hi,We are having problems routing our 192.168 addresses to the internet. When we add a default route it works fine but pushes out through that default route. Any ideas on what we are doing wrong? We have tried 100 things but nothing seems to work:!...

Currently we have a setup of link between HO and remote branch.HO is connected via leased line with v.35 interface.Remote site is connected through G.703 card to the router.We have done basic configuration, and still the link is down.We need to find ...

I just instal a ws-x6608t1 module in my 6513 catalyst switch and it would not power up. I ran the command power enable module but it is still not powered up. My 6513 runs 12.1 ios operating system with two sup engines. can sum one help me.

wharrison by Level 1
  • 411 Views
  • 1 replies
  • 0 Helpful votes

Dear SirI have a multicast application which must be run under the same subnet for hosts to communicate.. How can I do that under the following topology (bridging ??). Host A and Host B run the multicast application (but won't work if in different su...

bigeric by Level 1
  • 550 Views
  • 1 replies
  • 0 Helpful votes

I am trying to figure out if this is possible. I have a 2651 that I want to configure with Call Manager. It has 2 T-1's in it both going to different buildings which then complete a loop. I don't have the bandwidth to force the data and voice traf...

jobegates by Level 1
  • 445 Views
  • 3 replies
  • 0 Helpful votes

Dear Sir,I have one Cisco 837 for testing my multicast application. The setup is as followsHost A --- eth1 -- Cisco831 -- eth0 -- Host BBoth host A and B listen to the same multicast group (239.0.1.1) for mutual communication. This means host A send ...

bigeric by Level 1
  • 1840 Views
  • 12 replies
  • 0 Helpful votes

Dear Sir, I would like to know if the following setup worksHost A -- Router A --- Gre Tunnel -- Router B ---- Router C --- Gre Tunnel --- Router D --- Host BFor some reasons, I had to build another GRE tunnel between Router A and Router D (the tunnel...

bigeric by Level 1
  • 419 Views
  • 1 replies
  • 0 Helpful votes

About router summarizationsWhat Null will do in these situations? * If we enable summarization over EIGRP And we have Null record for some network (To discard any packet will match that record)So what happened if we have record to same network but wi...

mgattalla by Level 1
  • 608 Views
  • 2 replies
  • 0 Helpful votes

I have a question. We have a bad power supply in a 5500. It trips thecircuit breaker when plugged in. This is the secondary ps. There is alsoa spare 5509 that we have. We just have a questions on the powersupplies. Are the two PS's compatible?? One i...

fretbrner by Level 1
  • 430 Views
  • 1 replies
  • 0 Helpful votes