Routing

Hi; I have 45 branches, and having 1700 series rtr at each branch.also a tech support engineer is at each branch but i dont want to give him complete access to rtr but only few command which need to check the serial and to use ISDN dialup in case of ...

I have a E1 controller which has 6 timeslots range configured for 6 customers. Can I provide a loop to a particular customer such that other customers (of other timeslots connected via same E1 controller) do not get disconnected. Will giving loop on...

I'm looking for an up-to-date IOS image for 1721 with ISL support. So far I have tried about 10 images, but none of them lets me configure 'encapsulation isl' on ethernet subinterface. Any ideas ? Filename or IOS name would be just great. That box ha...

Hi Guys, i have 1760 router in my network, i was trying to upload the config threw TFTP, after uploading the config , restard the router , right now i am not getting any prompt, ASCII charater's are coming. pls give me solution for the same.Is IOS i...

Has anyone ever tried this; Bonded T1s with 8 channels of 1 T1 used for voice? I don't have much other information now so I am thinking that with CAS and PRI signaling this is doable however with PRI a MUX might be required.Any ideas?Thanks in advan...

Hi All,I need to setup an internet connection running BGP multihomed to two different Service Providers,both running 9 Mbps .I have an option to use either one or two 7206 for this connection.All my setup is in a single location(rackspace)My question...

Hi,I recently setup a solution to load balence traffic from a LAN over 2 ISP ADSL connections.The setup works perfectly for one major draw back. For some reason all the packets arriving on the fastethernet interface are being process switched :(This ...

is there any other way to originate a default route in bgp besides default-information. I'm receving a default route via an IGP and would like advertise this to bgp speakers without doing default-information orignate or having network 0.0.0.0 under b...

I am looking at something that I believe is a possible problem but can't determine. I have a router with only two interfaces - serial T1 WIC and FastE. The serial is a 768K frame circuit that is continuously running 95% utilization on both the tran...

I have next configuration.ip nat pool FRZ-natpool 172.19.25.33 172.19.25.62 netmask 255.255.255.224ip nat inside source list 1 pool FRZ-natpool overloadip nat inside source static 192.168.0.30 172.19.25.33ip nat inside source static tcp 192.168.0.17 ...

We recently purchased a Cison 1841 to separate traffic in our corp office between pc's/printers/etc. and corp application servers. The router came with 2 sets of start guides - Cisco 1800 Series Integrated Services Router (Modular) Quick Start Guidea...

Hi all,What is the best practice of using BGP router ID with EBGP?Can I use private ip address for the BGP router ID with my EBGP? or have to be public one, I know within IBGP, I can use private ip address. Please advise. Thanks--Bill

Hi, I do not get my MLPP to work (on a 3745).I have defined the multinks on the serial interfaces I wish to bundle : ppp multilink group 1encap pppand then defined :Interface Multilink 1ip address XXXX XXXppp multilink fragmentation disablemy channel...

Hi, I have this connection with these routers: RA(Internet) - RB - RC - RD(Internet)Between RA and RB we have 2 links, 1536 eachBetween RB and RC we have 2 links, 1024 and 2048Between RC and RD we have one link, 1536Now we have configured ...