Routing

I've been banging my head against this wall for hours. I give up.I'm trying to figure out what IOS release to upgrade my 2620 to. It's currently running (C2600-I-M), Version 12.1(2)I've been all over "How do I choose a... software release" but cann...

Hi,I haven't a good way to generate default route in my eigrp environment. who can tell me?Thanks a lotSincerely

Hi all,We have some troubles with Remote office connection when using an specific ISP. This ISP his off course not singled-homed and has Reverse Path Forwarding enabled. I know that provisions for asymmetrical flows (when outbound traffic goes out on...

Does anyone know of any issues using the new (to me) 2801 series router with BVI interfaces? We have not had a chance to work with these new routers and currently have our 2600 routers configured with BVI interfaces and wanted to make sure that they ...

We are currently running a 7206VXR router with two FastEthernet ports to an ISP via a 1 Meg link and we are in a process of purchasing a second router with the same spec and connect it to a different ISP also via a 1 Meg link. Which is the best way t...

is it possible to configure adsl using pppoa and aal5snap encapsulation?all the examples that i find show pppoa with encapsulation aal5mux.thanks

Hello All:Can I do this. 2 T1's terminated in 2 seperte routers but servicing clients on same subnet internally.So I would split clients ...some pointing to one gateway, some to the other.Let's say Router#1 FA0 - 10.0.1.1 <gateway #1>Router#2 FA0 - ...

hi all,i would like to know how to configure a frame-relay switch so that i can test point-to-multipoint frame-relay? thanks!i am using a 2500 series with 4 serial interfaces as the switch.

Hi All,When upgrade 3640 to 32F/128M, the flash should be 2 x 16 or 1 x 32 and the ram shold be 2 x 64 or 1 x 128?Thank You!Best RegardsTeru Lei

Hi All,Can anybody help me to know the commands that shows the port utilization for both CATOS & IOS.(commands other than show top & show interface)Your help will be greatly appriciated.Plz help me out.RegardsShahul

Hi thereWhats the actual difference in the 3 versions of Cisco 7301 router, when you consider the feature licenses.What is ment by "broadband aggregation feature"?

i have put up several posts regarding my problem (see below adsl problem) and no one ever answers.this forum is very quiet. i would appreciate if someone could give me an answer to my problem.i found the following bug CSCuk34163. could this be it?by ...

I have a question concerning ethernet ports on my Cisco routers. I am currently studying for my CCNA, and am trying to do a "Hands on Lab" scenario. I'm using the Todd Lammle Fifth Edition study guide. Page 232 if anyone has it. I have 3 Cisco 2500 s...

Hi,We have a 3845 with T3 link, and want to resell 10-20 T1s to customers. We were initially thinking of a bunch of NM-2MFT-T1 dual-T1 cards with NM-2FE-2W network modules, to buy as customer base grows.Is there a better and cheaper to do that, consi...