Showing results for 
Search instead for 
Did you mean: 


Forum Posts

                As per the diagram, I have two vlans (1 and 30). The server in vlan 30 is able to ping all the ip addresses in the diagram but the pc in vlan 1 is unable to ping What could be the reason it's unable to do so? I assume th...

network diagram.jpg

Hi.I have setup a fonctionning L3 SG250-08. Why L3 mode, because it works 1000 times more than in L2 mode (just test transfert file)My question was simple : as soons as i have configured some port in "switchport mode layer 3" all other port on the sw...

plavielle by Beginner
  • 2 replies
  • 0 Helpful votes

Hello,If we configure the EIGRP to load balance across 2 line with different speed let say link-1 is 20Mbps and Link-2 is 50Mbps, how actually EIGRP will do the load balance? Will EIGRP send to Link-2 more traffic than Link-1 since Link-2 have higher...

hs08 by Beginner
  • 10 replies
  • 0 Helpful votes

HelloI am trying to set-up the following site-to-site configuration.ENC are security devices that we must use.  There is 1 x encrypted tunnel between ENC01-ENC02 and another between ENC03-ENC04.  Between the two sites is an MPLS network.  The 2 x tun...

dasadmin by Beginner
  • 2 replies
  • 0 Helpful votes

Hi, We recently added another internet port to our network, I would like to pass through this port only a specific vlan The vlan is which will go through At the moment the routing of all our networks is through the FW. And I ...

shlomoi by Beginner
  • 6 replies
  • 1 Helpful votes

Hello,I am trying to practice for the CCNA but I got issue with the cisco 1841 router config, So the issue is I connected I have f0/0 and f0/1 as dhcp but I see only f0/0 show assigned to ip address and up but f0/1 connected to my laptop but still sh...

how do i add both inside(g1/3) and inside1(g1/4) links to nat to outside ? it seems like it's auto changing the nat statement for me . when i key in nat (inside, outside) dynamic interface, it'll auto change to nat(inside2, outside) dynamic interface...

tyr668_0-1691751060312.png tyr668_1-1691751070182.png
tyr668 by Beginner
  • 2 replies
  • 0 Helpful votes

Hello,I have topology like below picture, i have 2 location connected over WAN. All Core and Router using EIGRP and previously both WAN have same bandwidth 10Mbps. Now we will upgrade one of WAN so WAN-2 will have bandwidth 50Mbps and we want this WA...

hs08 by Beginner
  • 14 replies
  • 0 Helpful votes