Routing

There is additional path command to advertise BGP additional path to neighbor neighbor advertise additional-pathsTo advertise additional paths for a neighbor based on selection, use the neighbor advertise additional-paths command in address family co...

Hi Everyone,Does cisco OTV running over IPSEC ?anyone done this ?

Hi All, Just a quick question, does the g0/0 management port of the Cisco 9500-40x support U-Turn routing. Ive attached a diagram to demonstrate the issue. Ive read some of the guides but it doesnt show the exact scenario that I have. Weve recently h...

We have a 6807 switch as our core with vlans and ip networks setup internally.  Whenever I add a new vlan/network it gets added to the routing table and route to all of our other internal vlans/networks.  We need to create a new network and vlan that...

I've got to extend our voice VLAN over a WAN backbone. One of the old documents (2013) says L2TP does not support CDP ,LLDP, STP, or VLAN trunking, unless you use a L3 switch.    My current design is:  A1 switch with VoIP access portsA1 routerbackbon...

 I cant seem to find a simple definition of the difference between SAF service-family & address-family.Could someone please explain these two terms.

Hello everybody, The last 3 days ive been configuring a cisco 1941 router and a cisco catalyst 3750 switch for learning purposes. after configuring the router, i wanted to configure the switch with vlans. only the problem is that when i connect the s...

Hi,I have an RV042G Dual Wan VPN Router (Firmware Version: v4.2.3.14) configured to forward PPTP connections to a Windows 2012 R2 Server.I recently added a second ISP connection to accommodate the increased demand for bandwidth and everything else se...

hi   can u help me understand what is rd value in vrf i have seen it in bgp  and vrf configuration and can t understand whats the porpose of rd and rt value