Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi all, I have a problem with the cisco ASR1002-f, I can't boot iOS throught usb flash and flash memory. ASR1002-F logs:rommon 7 > boot usb0:asr1000rp1-adventerprisek9.03.16.05.S.155-3.S5-ext.binLocated asr1000rp1-adventerprisek9.03.16.05.S.155-3.S5-...

Hi everyone,Just wondering if someone could point me in the right direction. I am new to this and have spent a few days trying to get the hang of it, but now I am at a stage where I cannot go any further. I live in this UK with a BT Line which is VDS...

hexxcon by Level 1
  • 2769 Views
  • 7 replies
  • 0 Helpful votes

I have a Cisco 2921 ISR and a 2504 WLC. I have a wired network 10.0.10.0/24 and a wireless network 10.0.20.0/24. NAT, I'm trying to set up some kind of static NAT to make a wireless device (my phone) appear on the wired network so that I can connect ...

i All I currently have a twice NAT setup on Cisco ASA 5506 which works perfectly. However we are now implementing a Cisco ISR 4431 to replace the ASA, and wish for this device to perform the twice NAT function like the ASA is currently doing. Here is...

I have a Cisco RV042G router, set up for load balancing on two equal Internet connections.  I have set up protocol binding to route specific traffic from the local LAN for certain IP ranges/ports onto specific WANs.  One reason I needed to do this is...

Irv72 by Level 1
  • 333 Views
  • 0 replies
  • 0 Helpful votes

Current ASA configuration is working for Internet for 192.168.10.0 network but I want the others to work as well. So what I want to do next is feed the Firewall to the ISR which is then feeding my switch.On my Firewall on E0/2 I have 192.168.200.1 25...

I need some assistance configuring an automatic failover/backup route.  My network has a primary ISP that connects to an ASA at one location and a backup ISP that connects to another ASA at a different location.  Currently, if our primary ISP link go...

ssuttle1 by Level 1
  • 1717 Views
  • 7 replies
  • 0 Helpful votes

Hello Everyone im new to working in cisco enviroment recently i configure a cisco router for the customer and i configured NAT outside on the uplink interface which is coming from ISP and configured NAT inside on the LAN interface with ip address 192...

ADI.07 by Level 1
  • 781 Views
  • 5 replies
  • 0 Helpful votes