Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi All,  I copied the config of an Old switch to configure a new switch but when I login through https:// IP into the new switch, its showing the old location, check the screenshot attached, Is there any command to add the new location of the switch....

Visauk47 by Level 1
  • 1201 Views
  • 4 replies
  • 0 Helpful votes

I have a C6816-X-LE running the latest IOS 15.5(1)SY4. Here is my PBR configinterface te1/1 ip policy route-map PROV_USSATS ! ip access-list extended PROV_USSATS deny ip any 172.16.0.0 0.0.255.255 deny ip any 172.19.0.0 0.0.255.255 deny ip ...

Difan Zhao by Level 5
  • 2132 Views
  • 19 replies
  • 0 Helpful votes

HelloI have implemented DMVPN with Per-tunnel QoS. It works fine from Hub to Spoke, but I am confused with per-tunnel QoS between spoke sites. The Cisco documentation that I found is not clear/does not dwell into much details when it comes to spoke-t...

LaurentV by Level 1
  • 448 Views
  • 1 replies
  • 0 Helpful votes

Hi all,I have some annoying problem with NAT.So the thing is: I have a public IP range (69.168.66.128/25) assigned to some clients in building. Than I have a private network (172.16.0.0) and in this network I have a web server. This server supposed  ...

Hello Experts, I am facing issue with routing , specially with route-maps.Background:I have two ACLs , one for SAP and other for Rest traffic. SAP traffic must pass via MPLS and rest via Normal forwarding over internet VPN. Issue: Once the internet l...

Hello all Below statement found in cisco website, saying only non-fragment & initial Fragment packets contain Layer 4 header, and non-initial fragments do not contain.https://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation-gre/801...

IP Frag.JPG

Dear All,I am facing an issue since last 15 days. We are using Cisco 3845 with 2 ISP. One for data another for VOIP.We have 2 VOIP servers on cloud. We are doing Policy Based routing that any traffic destined for VOIP servers will go via 1st ISP and ...

We have a datacenter and several branch offices that connect to the datacenter via MPLS and backup Internet VPN. Our primary routing protocol is EIGRP (LAN and VPN), which is redistributed into our MPLS via BGP. Our primary connection for all IP traf...

Hi, I have two routers set up with HSRP connected to two ISPs, one cable and one DSL, so customers can always access our DMZ should one ISP go down. The routers are connected to our trusted network, VLAN1, and our DMZ, VLAN4.But trusted network PCs g...

ktravis02 by Level 1
  • 946 Views
  • 6 replies
  • 0 Helpful votes

Hello. I've got a pretty basic small network set up with a PIX 501 as the router. My inside subnet is a typical 192.168.0.0/24 setup. I received four IP addresses from my ISP (which I will list if you like), and I currently have one bound to the outs...

Unanswered Topics
Review Cisco Networking for a $25 gift card