Hey Guys, I am wanting to perform a baseline of our core network performance. What i am particuarly interested in is how many packets per second the core switches are processing and the current backplane performance. We are using older 3550 stackable...
Forum Posts
Hi Everybody; I am thinking in the implementation of a ASA cluster (active-standby), between my aggr core to the external router (which balance the traffic according IP's through route-maps) due to the company is growing fast and we need a extra secu...
What is the maximum amount of "ip service reflect" entries possible per Vifx interface? I am looking to split a single multicast low bitrate stream into 500 unicast destinations. AC
Hi All, I have a project for one customer, that is dmvpn as a mpls backup.There're several edge locations coming to two DCs each has one hub.There's currently mpls ebgp running on the network, then I want to deploy ibgp for dmvpn.I'm doing testing o...
Hi, I have been trying to find an answer around, and tried instructions posted around here, but I can't still make this work. I have the router working with my cable modem, and a server to which I want to make public on port 443 and others. So far, t...
Resolved! RP-bit set - Multicast
Hi All, I have a question about SPT switchover and the role of the RP-bit set. As far as I understand, once the SPT switchover is completed, the last hop router will send a prune message back to the shared tree. On the upstream router where the las...
Resolved! TCP/IP
Hello all Why internet protocol suite is called as a TCP/IP suite?We use both UDP and TCP as a transport layer protocol in different services. Then why the entire internetwork rules and conditions are called only TCP/IP suite? (why only TCP is used i...
Hi I am trying to configure High Availability on two Cisco ISR 4400 series routers. Each router has 4 interfaces. I have to connect both routers directly, as we have only 1 switch. I am thinking to use Gi1/1/1 on each interface to be connected direct...
Cisco router is 2911 with IOS 15.5-3.M7A gigabit interface with about 15 Mbit traffic is taking input errors and matching overruns. It accumulates about 150.000 per week. No CRC or frame errors on the interface. Cable is changed; speed/duplex are aut...
I've seen on places organisations using 10.0.0.0 Address class for VPNs & Intranet, Can anyone guide me why use this particular class??
Hi GUYS Pls find attachment why we need such Config , pls clarify thanks
Hi Folks, I am facing an issue regarding the connectivity of Gateway to Gateway Site VPN in RV042 and RV042G Router. I did configuration as per https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/smb3294-conf...
One of my customers is looking for an xlsx version of the log messages found in the following: For IOS devices: https://www.cisco.com/c/en/us/td/docs/ios/15_0sy/system/messages/15sysmg.pdf For IOS-XE devices: https://www.cisco.com/c/en/us/td/docs...
Hi we have a requirement to restrict the bandwidth on the 10G link as it will be split in to two sub interfaces with one set to use 40% and the other of 60 % of the bandwidth. But wanted some pointers of how to do it and how to calculate the burst ra...
Hello, I have an MPLS connection between sites and I need to measure the bandwidth capacity of the MPLS links. How can I do it? I have Catalyst switch 3750 and 3850.
