Hello!I have problem with transfer between VLANs.I have Cisco Meraki MX64 and switch. Transfer between VLANs (when I move files like .exe) is 30 - 32 MB/s is very slow ...When I move these same files in this same VLAN I have transfer about 600 - 700 ...
hi how do you configure a cedge where there is no oob? can you configure vpn 512 on say subnet 10.0.0.0/24 with ip of .1 and configure same subnet in vpn 10( service vpn) and have ip of .254 there so in essence loop management through vpn 10? can yo...
Hello TeamI want to allow only single system ip / bfd session and block all other. How to configure this via cli mode in sdwan
I am trying to upgrade an ISR 4331 running 17.3.4a to 17.9.4a. The device is in Controller-Managed mode. I have been unable to push the new software via vManage while getting a "boot partition cannot be found". It should also be noted that it appears...
Hi, sorry very specific one here. I've understand (from documentation) that under normal circumstances it's not expected or allowed to have SNMP RW enabled on a IOS XE device that's attached to vManage/Cat SD-WAN manager - I appreciate you want the c...
Hi Everyone,I have I problem with my SD-WAN topology. I can get any OMP peers between vEdges, what should I do?Here is the output
Hi, I have been exploring option to do NAT46 (from IPv4 to IPv6 Network) on Cisco Catalyst SDWAN devices. Is this option available or only NAT64 is available?
Dear all Friends,We are use Cisco SDWAN and have two links ( path)- Public Internet - Biz InternetBy default, we use active/active on both links, per-flow load balancing from Branches to HQ and HQ - to Branches.Now we want apply a policy for routing ...
Hello EveryoneWe are currently having 1 * Carrier in the VPN 0 (G0/0/0) whilst the Clients are in VPN 20. We want to connect Private SIP Trunks to the network and requesting for your advise if the approach below is fine.1. Connect the Private SIP Tru...
I wanted to be able to better understand how the SD-WAN topology works on a sandbox environment. However, I have not found any documents that clearly indicate this topology. Can someone please give me an overview?Because I can't access the device, I ...
I am trying to upgrade viptela image from cli because it's not managed by vmanage however i am getting the following error: vedge# request software install viptela-20.4.1.2-mips64.tar.gz rebootERROR: install: Kernel image not found Note that the MD5s...
I'm doing a SDWAN lab in and I'm unable to login into v-manage Gui using the username and password. its keep on asking the username password again and again. v-manage-version 20.9.3.1 if someone knows the solution, please help me with it. systemhost-...
Dear friends,I have an issue in with very simple centralized policy like below:I already ping , traceroute OK between site2 to site3 as picture above.Then I create centralized policy , make anything (IP protocol) goes from PC9 to PC10 , will prefer m...
i have a error no nat translations in sdwan the tunnels is up but ejecute cli this command and obtain no entries found sdwna1#show sdwan policy data-policy-filter % No entries found.sdwna1#sh ip nat translationsTotal number of translat...
I'm in need of assistances please. Our Viptela SDWAN design is a Hub and Spoke which have two VRF's. VPN200 interface has a vrf of 200 for Mgmt. and VPN100 has a vrf 100 for Customer internal network. I need to create a policy that simulates the defa...
