I am doing the Lab vManage on VMWare & all other devices are on EVE.I am Unable to add vBond to vManage via GUI. It says - "failed to add device cannot add vedge as a controller"Kindly help me Dharmendra.
Forum Posts
.
Hi all,why do we use of loopback interface as WAN link with color assigned in Viptela SDWANlike binding physical interface going to MPLS link under loopback interface and assignning private6 color to loopback interface and giving Private5 to Mpls phy...
Resolved! Eight vManager show up
Hi One vManager and one vbond are installed. Why it shows 8 vManager? Thanks
Hi am new to Cisco SDWAN (Viptela)I have couple of quires if some one can answer wit will be great !!!Can we have cisco SDWAN (Viptela) on virtual machine ? with out any edge device from cisco ? if possible what are the hardware specs for host machin...
We are wanting to consider a Cisco SD-WAN deployment this year and I'm wanting to confirm if I can do a partial deployment. For example, I have approximately 60 branches that communicate back to a primary data center location or alternatively a DR s...
Hello team, Is it possible to run an IPsec VPN between a traditional router and a cEdge on the service-side VPN? Especially with the following use-case: - the traditional router doesn't have access to the WAN transport, - the traditional router is co...
Resolved! Allow-service in vbond/vmanager
Hi Below is config for sdwan vbond or vmanager. There are a lot "allow-service" as we can see. I would like to know any allow-service has any significance if there is one "allow-service all" on the top? Thank you! vpn 0interface ge0/0ip address 192.1...
Dear All,It was easy to understand the most of the basic networking concepts with few devices(PC1--SW1--R1--R2--SW2--PC2) in GNS3.Can some one please let me know if there is a way to start learning SD WAN in similar way.
Hi vsmart, vbond, and vmanager are configured and ping each other. All allow-service are enabled. But the vmanager cannot be accessed like below. Is there something wrong or else? Thank you vManager# show running-configsystemhost-name vManagersyste...
Resolved! vmanage license for device
Hello, I would like to know if the vmanage license is subject to a number of computers that it can manage. Thanks,
i upgrade database of vmanage 20.4.1 , whem i am trying to access it via web broswer it give me blank pagr , i can not get dashboard of vmanage
Has anyone set up Cisco SDWAN with Riverbed Steelhead WAN Optimization appliances in virtual inpath mode? We currently use WCCP on our WAN routers to peer with the RBs. WCCP is not supported in the SDWAN code and PBR doesn't fully work either. I've b...
I'm curious what is possible values of device state property got as result of executing request to "/dataservice/device" endpoint of Cisco SD-WAN vManage API. I cannot find this info.
Is there a way to perform an upgrade to a sdwan cedge router in Controller mode from the CLI if the image is in the bootflash?Thanks!
