SD-WAN and Cloud Networking

Hi,  Is it possible to find the configuration pre and post of a cEdge ASR? We recently went from 16 to 17 code and a config backup was not taken before. We think a command may have been removed but I can't find the original configuration before upgra...

xxx-xxx-gw1(config)# logging discriminator yyyy ?Possible completions:facility mnemonics msg-body rate-limit severity <cr>xxx-xxx-gw1(config)#  When do we use facility option or mnemonics option or msg-body when building the logging discriminator con...

https://sdwan-docs.cisco.com/Product_Documentation/Command_Reference/Configuration_Commands/tracker I saw the above link regarding tracking. It mentioned it is supported only for vEdge.Does this means it will not work if I configure these in cEdge. D...

What would cause a vEdge to NOT attempt control connections to vSmarts for an MPLS TLOC? I have max-control-connections set to default (unlimited). The LTE TLOC is making such connections but I don't even see the vEdge attempting to do so for the MPL...

I am begginer to SDWAN , i created test environment, I have VPN 0 , VPN 10 and VPN 20. Each sites running OSPF and  I created ospf template with ospf default route pointing the Vedges. My sites working fine witout any issue ,My Question is , how do a...

Hello, As I was trying to push vManage (version 20.7.1) templates for vManage itself, I lost connectivity to the GUI interface and currently, I am not able to configure vpn0 and interfaces again because template overwrites itself. So, I need to go ro...

Maybe someone has already connected 2 separate vmanages? I have 2 vManages deployed that are behind NAT, vbond have public ip addresses, in the DR master you need to specify ip vbond, will these be public ip or management ip addresses (vpn512)?

I have an SD-WAN router C1111-8P. I'm unable to enter the global configuration mode with this router.With C1121-8P I can enter global configuration mode by enabling the autonomous mode.Is there a similar process in C1111 router?

I’m trying to interpret the Viptela documentation, and I’m coming across some apparent contradictions, probably because I don’t have all the facts or understand them. Can anyone enlighten me?   I understand that VPN0, the Transport VPN, must be confi...

Hi, I'm trying to monitor CPU & Memory usage with our vEdge 1000 SD-WAN routers by adding OID values to our SNMP tool.What are OID values can I add for monitoring each CPU & Memory usage?

If i ping 8.8.8.8, what mtu value will it take. Let say i have kept default mtu 1500.   Below is sample output from SDWAN device which have 3 transport wan connections verified all three connectivity upto 1472 is reachable beyond that traffic is gett...