We recently announced the release of our self-serve virtual assistant. You can read the full announcement here. Videos and documents are available within a click for our latest products. Once you've told the bot what device you're using, the context ...
Forum Posts
(Updated September 2023 - Added Catalyst 1200 and Catalyst 1300 ) Hello! This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful. Catalyst 1200 & 1300 Hardware Install...
I have tried multiple instructions on resetting this switch (Cisco 2960L-24PS-LL), but nothing I do works.I have held the MODE button while powering on the switch for various intervals (from 15 seconds all the way up to 2 minutes)I can access the con...
Hi I have an SG500-28P that is behaving oddly. Factory Reset via button on the front took ages to respond, I have been told 10 seconds or above and it should flash all lights and reboot. It does not. Finally got it to reboot and now it goes through t...
I just purchased a Cisco CBS250-24P-4G 24 Port Smart Switch with the intention to mount it in a rack. The unit came with a mounting kit but the brackets force the switch to stick out more than an inch.Are there brackets that enable a flush mount so t...
Me comentan que este modelo ya esta fuera del mercado, es así? y de ser así cual seria su sustituto ? Y es posible que sea sin NA?
Hello, what are "non-XG" devices that are referenced in the manual like in the screenshot i posted? I have a CBS250-24P-4X switch, does the "X" mean it's an "XG" device?
I'm looking for a way to get MAC addresses on a specific port that doesn't include all possible ports.For example, I want all mac addresses listed on port Gi1/0/2. I don't want MAC addresses listed for ports 20-29, just 2. "sh mac add | i Gi1/0/2" d...
I upgraded the firmware on my Cisco 350-28 Managed switch to the latest (2.5.9.54). After it rebooted, I was no longer able to log into it with the credentials which formerly worked. It is working fine, and everyone on my LAN has internet access, b...
Hi, I have a CBS-350 series switch and want to check whether it supports the VTP protocol. Do you know how I can do that? Thanks,
We have irregular problems with passwords on Cisco SG250/SG350/CBS250 devices – more precisely with password changes. We suspect that it might be perhaps due to special characters in the password. Possibly "only" the web GUI is affected and not the S...
Hi thereI want to replace an ubiquity switch whit a device from Cisco. The only switch which meets the form factor requirement is a CBS250-8PP-D.So I bought one and face a strange problem. As soon as I connect a computer to this switch the switch shu...
Hi team i want to check warranty of my Cisco device so we can extend warranty with you and i have check with your tool warranty finder. This tool not provide correct information. So, please provide right tool for me so we can check ;warranty stat...
Create a new Contract, with a New Location
Hello,I see from my logs in SG220-26 26-Port Gigabit Smart Switch:NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on gi1, with Cisco-SG220 gi25In same switch gi1: From show running config: Can you please help me solve this? I don’t understand. ...
I have 2 CBS350-24XS 10G switches stacked. My two physical firewalls running active/passive HA are connected through port 1 on each switch. My stacking ports are all setup in native mode using the last two ports on each switch.I'm running into a prob...
Hi All,The note is from Cisco switch STIG requirement that I need to implement in all my switches in the network. Rule Title: The Cisco switch must have all disabled switch ports assigned to an unused VLAN.Discussion: It is possible that a disabled p...
