Storage Networking

Hello,We resently changed ISCSI NIC's on all servers to jumbo fames 9014 and flow control (generate and Rx).  Then programed C3750 identical as listed in document link below setting system MTU and flow control.  I have provided output from C3750 show...

Hi, Recently, I came across the interesting case, I could see the Rx and Tx power is N/A and and I have flogoi session established on that port.. I just wanted to know, does Rx and TX has nay relation with Flogi or connection between HBA and Switch p...

I'd like to upgrade the OS on our W2k3 to W2K8 64-bit via virtual machine. First, is it possible to run Cisco Fabric and Device Manager under VM 2K8 64-bit? Has there been any issues reported running these tools, on VM? Thanks

Hey Guys and Gals, I need to set up alerting for discards on certain ports in two 9509's. Does anyone know if this can be done? Is there a mib for it? If there is where do I start? Thanks for your help, JF

Hi,We have an MDS 9513 that has a slot that is maybe a defective one. Whenever we installed a switching module in that slot, that module can't be powered-on. Somebody suggesting that maybe a Supervisor module is causing the failure. Is it possible th...

I'm trying to build a config for a Nexus N5K-C5548UP-FA that will have a mix of FCoE and native fibre channel ports.  What licensing do I need to purchase for the chassis to support this functionality?  I'm not anticipating that any of the FC connect...

Hi all,We just purchased a new 9509 to replace our older 9509. I would like to migrate all of the zoneing information from the old switch to the new switch so I can move my host connections over intact.We have a mix of Win, Linux and HP-UX. I am unde...

HelloIs Cisco device manager supported on windows 7 ?If yes how to install Cisco Device Manger on Window 7?Please adviseThanksChetan R

Hello,Let me start off by saying i'm new to MDS switching...Currently, all our Windows/esxi server hosts are connected to 2 MDS 9148's and a back-end EMC NS-480.  We are about to migrate from the NS-480 to a VNX 7500 and looking for the recommended/s...

We are building a new datacenter and is starting to set up the SAN.This small DC consist of 2 Nexus 5596UP, a Compellent SAN and 2 Dell M1000e cassis with blade servers.naive FC part in Nexus has been easy to set up but we have problems with the FCOE...