Hi Guys, I'm trying to connect a Quantum Scalar i40 Tape Library (with HP Tape Drive) to a MDS-9148.Below are the MDS version information:BAMDSPR01# sh versionSoftware BIOS: version 1.0.21 loader: version N/A kickstart: version 6.2(7) sys...
Hi all,Can anyone tell me how Fabric Manager does its discovery of the SAN fabric and is there a command line equivalent e.g. equivalent to CDP? I need to make a network map of the switch connectivity if possible? thanks Chris
Hi,we have a setup with a nexus 5010 and 2 ucs c200 m2 with p81E CNA. We have configured the nexus with one vsan, 20, and two vfc. Every cna is bound to his own vfc, and we can see the VFC up, but the vsan operational state is down...attached the rel...
I have an MDS9124 that is connected to an MDS 9124e connected into an HP blade chassis. I notice then when looking at the fc domain status, the 9124e shows as running at priority 2, even though that priority is not configured in the running config....
Hi all,We have a couple of Nexus 5548UP.Nx-OS = n5000-uk9.7.0.5.N1.1.bin monitoring traffic of FC interfaces was working fine until we upgraded to 7.0.5.N1.1 from 6.0.2.N2.1.We didn't change anything on our Nexus config and on our Centreon monitoring...
Hi,I am a little confused about how a servers would decide on which VSAN to route through when there are two VSAN confiured. Considering the following topology where we have VSAN 10 and VSAN 20. MDS1 is configured for VSAN 10. MDS2 is configured for ...
Need some Help Here: I have two Nexus 5548 connected to each other Via Port san-portchannel. The Members of the Port channel go to VSAN 1 by default. How Can I add my Ports which members of VSAN 200 to the Port Channel. Here is what I have on two ...
We recently upgraded our DCNM server to 6.3(1) and we've noticed that the server hosting the DCNM application is doing more IOPS than any server in our environment!It seems to be doing 8,000 - 10,000 IOPS constantly.In Windows you can see that postgr...
I have been trying to perform an NDMP backup between A HP LTO5 Ultrium Tape Library and Netapp with the MDS switch providing the fabric.However, everytime I initiate the job, I experience this problem. Below are some of the outputs on the concerned F...
Hi, Have a new DC solution with Nexus 56128 switches running LAN + Native FC.Storage Arrays shall be connected to the Nexus switches via 8G FCCustomer has Dell blade with Qlogic SAN switches, where existing zoning is done. Today these are connected t...
I'm having an issue seeing the switch and managing VSAN's and zoning from within DCNM Fabric Manager. Device Manager and Fabric Manger discover the switches, however, Fabric Manager won't let me configure anything. When I try to edit the local zon...
Dear Team!I have software Cisco Fabric Manager 4.2a (in SAN management server based on Windows Server 2003) Standalone version, which managed our existing fabrics (we have 2) now. In case of OS "Windows 2003 server" going to End of Life/Support, we s...
I have two older MDS-9124s that we are replacing with MDS-9148 as part of an overall SAN upgrade. It is possible to simply interconnect one 9124 with one 9148 and basically make a stack as the first step to replacing the 9124? I am thining this would...
