Switches - Small Business

We are currently having a problem with our high availability environment whereby the cluster loses quorum and all the VMs reboot when the CISCO master is power cycled.  The relevant components in the environment are shown in the attached PDF file.  ...

Hi, I am trying to get VLAN information from an SG500 switch, basically the VLANs each port carry in trunk mode and the VLAN id for access ports. I found some entires for VLAN under .1.3.6.1.4.1.9.6.1.101.48 using  CISCOSB-vlan-MIB.  Basically it ex...

The SG300-10 powers up, cannot reach web interface.  Console connection will not start.  All ports are flashing power light is off.  I cannot reboot with reset, or factory reset. Any suggestions.

Hi, I am texting this discussion 2nd time.  Still waiting for the assistance in this case. 

I have a PC with 2 NICs in it.  One has all of the normal Stuff, the 2nd NIC has nothing checked in its Properties.  2nd NIC is connected to an SG300-52 Switch setup as General Access, untagged VLAN 101. No RMON/Port Mirroring or anything special. On...

Hi, looking for some help with output drops.  2 stacked 2960x switches were installed Feb 2016.  In that 2 month period some ports are showing tens of thousands of output drops.  The 2-link port-channel trunk is gigabit and has 188k output drops.  Ac...

Hi there, We have a number of small business 500 series stackable switches.  I have a lot of experience with Catalyst but not so much with the SG500.  I decided to conduct a failover test on the one stack of 2 switches.  Here are my methods and resu...

Hi, I need to configure NMS system to poll SG300 and SG500 series sw's using snmp. I have found CPU oid's, but I haven't found memory oid for SG300/500 products. I have tried to check mib files, but did not find mem oid there. Can someone give those...

I inherited this switch when I took over IT Management for my current employer. I know very little about it. Yesterday I successfully reset the cisco password via serial cable. Now that I can login to the web UI, I see the firmware is quite old. It i...

I have a few SG220 switches with code 1.0.0.19 and ports are show input errors and throttles on ports connected to APs.  I am seeing it impacting wireless connectivity as well connected to Cisco 2602i and 2702i APs running 8.0.121.0. I believe this ...

I have a few SG220 switches with code 1.0.0.19 and ports are show input errors and throttles on ports connected to APs.  I am seeing it impacting wireless connectivity as well connected to Cisco 2602i and 2702i APs running 8.0.121.0. I believe this ...

Hi I am setting up a office which currently has only one  switch, which is 2960x. Knowing that it supports  some of the L3 feature through "Lanbase routing" VDM. I have done the same. Following  settings have already  been done : 1. Loaded the right ...

I have two issues with my SG300-52 switches. I have configured the same VLANs on both of them for availability and redundancy. The switches connect to a router, and clients get IP addresses from a 2k8 DHCP server. My issues are: 1. I get 2 or three ...