Switches - Small Business

Anyone have any tips for automating the backup process of the SF500? Thanks

Hello, does LAG work across stacked SG500 switches? I would like to create LAG with ports on multiple switches to achieve switch redundancy in case of failure. Administration guide does not provide any info on this issue if I am correct.

I have a 48 port small business switch model SLM248P.  It currently has firmware 2.0.0.10 on it. I have been unsuccessful in trying to configure it using modern browsers (IE, Firefox, and Chrome) I have been scouring Google and the best that I have b...

Hi, on my SGE2010P switch i have 4 configured vlans: 1 (default) 10 (Team A) 20 (Team B) 91 (Guests) Members of team A and team B should be able to cooperate so inter vlan routing is fine between 10 and 20. This already works fine. The wifi hotspot ...

Cisco SG300 - Is it possible to have IP Source guard work by MAC not by Port? Problem: We have our Ubiquiti wireless APs hooked up to an SG300-10P. The user's MAC can roam from AP to AP without asking DHCP for an address. We want to have IP Source Gu...

Hello! We are using cisco SF302-08P switch to aggregate four VLANs from two WiFi bridges and connect them to internet. Everything works well before new hosts adds to the network. If we connect new PC or phone it doesn`t "see" internet before we reboo...

Hi Is this a problem with sg300 not being stackable - We have an sg500 stack and all the switches happily communicate over the voice vlan (10) and the default data vlan (1). I have connected an sg300 to the core switch, created voice vlan 10 on it, ...

Hi, I have just got a SG300-10 switch for a home setup and I'm not sure how to set it up. I've read quite a bit on various forums but most of it seems to be quite a few years out of date. For example, I spent a while trying to get a serial connection...

I am stuck trying to figure out how to enable ssh or telnet access to an ESW-520 switch through the web console.  If any one has any detailed instructions on how to accomplish this I would be very appreciative.  Thank you

We have Auto VoIP feature (VLAN Management > Voice and Media > SIP/H323 Based) enabled on two ports on a Cisco Small Business SG200-08 (Firmware Version:     1.0.6.2). Logs show the following messages once in a while: 82     2015-11-19 12:00:04     I...

I have a SG200-26p switch that doesn't show the icons when you log into the switch.  Also, the switch's IP doesn't show when I scan the network.  If I reset the switch to factor defaults, then the switch acts normally for a little while (~hour or so)...

Could you please tell me difference between 2 Switch device part number SRW2016-K9 and SRW2016-K9-NA? I wonder the NA code.

Hi. I recently bought Cisco sf300 48PP POE+ to power my IP POE powered cameras and it works great. But here's the thing, I want to schedule them to work only on certain hours. So I want to cut power on certain or all ports or even turn off whole cisc...

I have a Cisco SG 200-08 installed in network. We are able to ping the switch and connect the network, but Web Interface is not working. I am unable to login into Web interface and make the Changes. If I connect switch directly with my Laptop it work...