Switches - Small Business

We have several SRW2048 switches which are running OK - however one of them is logging the same error several times every minute.The error is  :-04-09-2014 15:50:05 Local7.Warning 192.168.0.20 %UPNP-W-DBOVERFLOW: UPnP retransmission DB overflow.I've ...

If there any procedure on how to update the boot code on a SG300 10MP, to 1.35.06?  I can't seen to find anything Any help would be awesome

I have had no luck with a new SG200-08 switch, firmware 1.0.7.4.  It never acquires an IP address from the upstream server (System LED flashes continuously and forever) yet plugging the same cable into a PC or laptop results in an immediate and succe...

Hi,I wanted to add an SG500X to an existing stack (Native stacked pure SG500X-Stack) and it always fails, all LEDs on, System LED blinking Amber (according to the Admin Guide this is Hardware failure).The eventlog on the Switch says, that boot code u...

Upgraded an SG300-20 from 1.1.1.8 to 1.3.7.18 this afternoon.  Bootloader was old enough I figured it probably should be updated as well.  No way to do it through HTTPS, so it's time for TFTP.  Documentation not great.  Start up TFTP server, log in v...

I want to have multiple VLANs share an internet connection. Can this be done with an SG-300-28P in Layer 3 mode, directly connected to a cable modem, with no additional router?Does anyone have a simple example of this? CLI or web interface is fine.Th...

Hello,I have 4 sge2010P configured as one signle switch stack.  I've vlan1 (default) and vlan100 on my router and switch stack.  vlan100 is tagged and dedicated for voip phones.  vlan1 is for computers and printers.  How do I configure qos on vlan100...

Hello,I have been messing around for some time now to get my network to work with some vlan's All tutorials and other posts in the forums didn't really help, I only have basic knowledge about networking.I have drawn a network map as I would like to b...

Hi alli have a sg300 switch and i have configured a guest vlan.VLAN 1 = productionVLAN 40 = Guest Wifi ( on port 10 ) i created my ip interface192.168.1.254 ( vlan 1 )  192.168.40.254 ( vlan 40 ) and created my gateway 192.168.1.1i configured a route...

We've been integrating and verifying some RSTP-capable hardware and have discovered what appears to be a minor bug in the SRW2008 RSTP protocol implementation. We've discovered that the SRW2008 switch fails to become the root bridge in spite of havin...

Dear TeamI am using sg300 for voip. i have created 5 voice vlans for different departments in my office.but my voip is not working. only 1 voice vlan is working out of 5 voice vlans. The voice vlan working is agreed voice vlan in sh voice vlan commad...

I have configured the storm-control command at a customers site as follow:Storm-control broadcast level 30Storm-controlaction shutdownMy understanding of the above congiguration, is that should the broadcast level go over 30% the port will be shut do...

Hello,I have 4 SGE2010P switches, and would like to know if they will work with Cat6A cabling. Shawn