Switches - Small Business

Hi,I'm trying to configure a SG300 to be reachable beyond its own subnet. Its IP address is configured by DHCP to 192.168.2.2/255.255.255.0. It is possible to ping the switch from the same subnet but not from outside. The switch is set to layer 2 mod...

Amigos tengo un switch modelo SG 200-26 el cual como primer indicio comentar que el LED system parpadea intermitentemente. Luego esto enchufo un cable ethernet a un puerto X y éste parpadea como maximo 3 segundos en verde y luego se apaga completamen...

Hey,I'm redo-ing my entire network infrastructure in my small business and I'm completely crossed on which products to buy. I need 20-25 ethernet ports + WiFi. I don't need any special features. I have two Comcast business class internet modems with ...

Hi Alli have a SG300-52 Switch, route mode is enabled, and it is using the latest IOS.I have created 4 Vlans in this switch, till this point its OK, but once i try to give ip addres to the created Vlan either from the GUI or CLI the switch is not res...

I would like to cut the noise from my SG200-26P. Any fan suggestions to replace the stock fan with?Can anyone tell me the size of the original so I can look for an alternative?Regards ChrisSent from Cisco Technical Support iPad App

Hi there.  I have a Sf300 switch running firmware 1.2.7.76.I've noticed that whenever I removed a tagged vlan from a trunk port, the native Untagged vlan is always reset to 1.This seems to be a bug with the firmware. Has anyone else run into this?  I...

Hello,We have netwotk 192.168.1.0 with the default gateway 192.168.1.1 (Juniper Netscreen Firewall). I bought the switch SG500x and want to use as backbone switch. It will be placed between the Juniper and other layer 2 switches.I want to use this sw...

                   I owe a SG200 26 port switch and it works fine so far.Amacintosh computer (mountain lion) has been added to the wired net. Everything works fine t first, but there's a sudden disconnection issue.It seems that the macintosh computer...

Has anyone found a fix for this?  We purchased a SG300-52 last week to replace a 5yr old Dlink which has worked perfectly.  1 day after the SG300 went it it started crashing with this fatal error problem so I reverted the firmware back from 1.2.7.76 ...

Hello....we have a new series of Cisco SF-200s and one new Cisco SF-300.  All switches are operating in layer 2 mode currently.  Let's say for all intents and purposes, all ports are in VLAN1....pretty much default setup.  There is a fiber backbone b...