Switches - Small Business

Hello to all,We have a Cisco 887 router and a Cisco SG-200 switch.We'd like to setup trunking between these 2 devices for multiple VLANs on the switch to be made available on the router.With previous routers, you could set the router up in the config...

Hello,I have purchased a Cisco SF 302-08P 8-port 10/100 PoE Managed Switch with the intention of creating VLAN's for my home network. The idea behind this set up is having 1 network for gaming and the other for work. I am thinking on having 2 separat...

Hello!I have number of SF300 switches in production and have found bug with command "interface range".When I reconfigure interfaces previously configured with "interface range" to different VLAN interface change VLAN, but after reboot it move back to...

HiDoes anybody know which wrr queue in sge2110 has the highest priority? We can use weight 1,2,4,8 as described in manual, but i'm not able to find information which weight defines the queue with the highest priority?In the simple way -  which weight...

Please see attached Diagram.  With my current setup, it doesn't seem like traffic is moving from FE8 to FE7 on Switch #2.  Any suggestions?My Desired Outcome:Have Multiple VLANS on FE8 on Switch #2 talk with their respective VLANS on FE7My current se...

How does the ESW 500 or SF300 line guarantee QoS of voice traffic when trunking switch to switch? I have (2) ESW 500 series switches in series. The phone on switch 1 have no audio issues, but the phones on switch 2 (the last in the series) have inter...

Hi All,I have an SG300-52 gigabit switch that has been constantly rebooting and is effectively unusable.This started after Enabling TCP Congestion Avoidance, specifically:Turned on TCP CASaved Running Config -> Startup ConfigRebooted SwitchSince then...

I was given a linksys SRW224G4 switch .. It seems to work fine on some ports and others dont .. I am tring to log into it to see what the current config is .. but no luck .. I cant seem to find what ip address its pulling to be able to log into the w...

I am getting the following message in my logs on SF300-8"%CDP-W-NATIVE_VLAN_MISMATCH: Native VLAN mismatch detected on interface fa1."What is causing the error, see VLAN setup below:

Hello, I am building a new home with several Cat6 ethernet ports wired throughout (at least one to each room) and I want to connect them all through a rock-solid reliable gigabit switch like the SG300 or SG200.  I am also going to use wireless N (som...

Can anyone confirm for me that the SLM2008T does not have the ability to add Port Description or Login Banner like the SG300's do?  I knew there would be some features that the 200 would lack, but I've never seen a smart switch that did not have the ...

Hi,I have the following problem with routing between vlan on SGE2000 switch configured in L3 mode:I have 2 locations connected througn vpn with the following ip's:HQ class configured on cisco router (i do not have access on that because is the route...

I am not a big tech guy. I'm trying to help a friend do a factory reset of a recently acquired used SRW2024 but he is claiming to be unable to access the switch because the default IP address has been changed. This model has no reset button anywhere....

Hello,The SMART Designs state that both the ESW500 and 300-series switches should not be used for deployments of over 100 IP phones.But now that both the UC560 can go up to 138 (128 IP phones) and the BE3000 can go up to 300 users is this design rest...