Switches - Small Business

Is there any issues with accessing the browser based GUI using Windows 7  64bit on a SGE2010 switch? I took the switch home and tried on my XP 32bit machine and works fine, but no luck on any windows 7 64bit pc's. I have tried 3 different new pc's on...

HI,Is this switch model ESW-520-24-K9 is supported by Cisco Network Assistant.In the leatest release notes of CNA are supported Catalyst Express 520 Series Switches and this model WS-CE520-24TT-K9 is on the supported list.But the mention model above ...

We have 2 of the SG200-26 switchs. When ever we loss power all the settings are reset to default. Even if we loss power for 1 min. This includes the IP, user, password, etc. How can I change this so the settings are saved?Thank you

I need to purchase a few Gigabit PoE switches for a small business and I am thinking that SG200 or SG300 switches are perfect for this purpose.Layer 3 functionality in SG300 switches is not great - HSRP or any other next-hop redundancy protocol is no...

We are trying to create a 4 member (4Gb/s) static LAG group between two switches, a Cisco SLM2048 and a Cisco SG300-52. The LAG group (4 x 1Gb) shows up on both switch and we do get 1Gb/s of throughput between the switch but that’s it. Testing with a...

Hi!Previously srw2008 switches are used, now Cisco sg300-10 models was obtained.It does not work with ctrl-Z command to enter the local Config (lcli)Does anyone know the correct command?THX: deresotto

I've just purchased 2 switches SG100-24 and use fiber cable to connect these switch together. I plugged cable in module MGBSX1 and then put it into miniGBIC uplink port but despite trying many times, also rebooted devices, I still not make these upli...

Hello,We recently replaced a Netgear 16-port JGS516 gigabit switch with a Cisco SG200-26 switch.  When we did, we lost our ability to talk to our WTI CMS-16 (Western Telematics 16-port serial lines).   The CMS-16 has a 10Base-T Ethernet, RJ45 connect...

Здравствуйте, у меня 2 свитча  SLM2008Только на одном через несколько часов работы падает скорость, подключено 3 компьютера на скорости 1гбит и роутер на скорости 100мбит, скорость с 1гбита падает до 5мбит, при этом соединение показывает 1гбит. Помог...

SRW 2048-EU(webview) switch will support how many SFP minigibic whether 2 or  4 ?

Hello,We recently installed a 200 Smart Switch.  I changed the IP address to 192.168.210.2 and everything was working fine.  Everything is still working fine except that I now can not access the switch using the IP address.  I can not ping the addres...

We are trying to implement a SLM2024 into our environment to be used on a  lab bench. I am trying to get trunked traffic from a Catalyst 4948 to  this switch. The Cisco documentation on how to do this on the 2024 is  not very good. Does nyon know the...

Hi, anyone knows if there is a way to configure a secondary ip address (over the same address range) in a vlan interface on the SGE2000?For example, I want Interface Vlan 10 on mw switch has 172.16.10.1/24 and 172.16.10.2/24. Is that possible? If I t...