Is a 3D Model available for C9500‐24Y4C‐A
Is a 3D Model available for C9500‐24Y4C‐A
We have a problem with 'IP DHCP SNOOPING', we have port on switch that it is connected a access control device, but, it doesn't work when we set port with 'ip dhcp snooping limit rate 10', we snifered mirroring this port in notebook with wireshark in...
Hello,I have been trying to solve this project that was provided in my course.I am rather confused as to how to correctly construct my diagrams. I have googled how to configure ripv2, dhcp, vlan with vlsm and static routing. but I can't seem to draw ...
I ordered a L3 Catalyst 3550 switch from ebay, plugged it in and was greated with these errorsIOS Version 12.1(14)EA1A00:32:48: %ILPOWER-3-CONTROLLER_ERR: Controller error, Controller number 5: accessing failed00:32:51: ***Err: I2C_do_transaction fai...
See attached diagram: I need to do the following: (NOTE: The Firewall and the EIGRP are connected to VRF-C / REMOTE SITE and TRANSIT routers are in the same location) For VRF-B to Communicate with VRF-C, the traffic has to go through the transit site...
hello, if i have 2 layer 3 switches and a set of layer 2 access switches in between so it forms a loop (the layer 3 on the edges of the loop and the layer 2 access switch in between as a physical connectivity), is that will affect the HSRP response c...
Hello everyone,I just finished my MPLS configuration but I have one last roadblock. I can reach my HQ LAN(10.10.1.0/24) from my branch but HQ cannot reach branch LAN(10.10.3.0/24).This happened after I did NAT outside and NAT inside on the branch rou...
hello, what kind of switches can we use instead of industrial 5000 switches with same or better performance specially for the operation environment category and have at least 8 10GB ports. the limitation of industrial 5000 switch is that include only...
We have a network based on DLink 3120 switches. How can I integrate Catalyst 9300 switches into our network as a distributed layer?
Hi! Does anyone know here what is the command for these tasks?:Configure static routing on HQ with route summarization to VLAN 10, 20, 30 and 40. Identify and configure all other remote networks of HQ.Configure static routing on R1 with route summar...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
09-17-2024 12:44 AM | ||
09-12-2024 02:06 AM | ||
08-28-2024 02:25 AM | ||
08-20-2024 09:12 AM |
User | Count |
---|---|
10 | |
7 | |
7 | |
5 | |
4 |