Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi Experts , I have a small doubt regarding the span of ethernet ports , which are part of port-channel on nexus 5596 switch. As per Cisco documentation , we can SPAN port-channel and only RX traffic can be monitored. I have 2 port-channels on Nexus ...

Hello We're looking at the Nexus 31108s and wondered if there are any differences between the C31108TC-V and the 31108TCV-32T models apart from the number of RJ45 ports (48 vs 32)? Also, are the 10G copper ports capable of 1G or are they 10G only? Th...

aok by Level 1
  • 1742 Views
  • 4 replies
  • 0 Helpful votes

When you configure an interface on Cisco 3850 switch to be in a specific vlan you enter : 1)switchport mode access2) switchport access vlan ...number...  why do we need both commends if the second command is enough? 

HI I am getting an error while booting Cisco 2960.SYST strat blinking green then amber than all lights goes off. When I Connect the console cable and push the MODE for 15 Second I am getting below only     Boot Sector Filesystem (bs) installed, fsid:...

Laithmh by Level 1
  • 683 Views
  • 3 replies
  • 0 Helpful votes

Hello,I’m creating this post because I get a problem with my new C2960XR switches. Indeed, POE is not working well. I am migrating from a C3750 switch and POE works fine for the same devices with this switch. Configuration is the same for both device...

Simon0754 by Level 1
  • 1082 Views
  • 6 replies
  • 0 Helpful votes

Hi, We have recently installed a Cisco WS-C2960L-SM-24TS 15.2(6)E2b.For reminder, the switch is configured on Web interface and cli on read only. I have configured a port in access mode vlan 7 and then moved it to trunk.The issue is that on cli, i ca...

Hi everyone: I am trying to have a switch working(some one gave it to me as a gift, is a used switch but it was working). due to their company rules they deleted it before they gave it away. I just want it to hard reset it so i can practice for my CC...

Roldan by Level 1
  • 8386 Views
  • 16 replies
  • 0 Helpful votes

I have a Cisco Catalyst  3850 -24XS that has 10 extra interfaces showing up in the running config. These interfaces would belong to a network module; if I have one installed.  Does anyone know how to remove these interfaces from the running config. B...

Marquis by Level 1
  • 1004 Views
  • 3 replies
  • 0 Helpful votes
Unanswered Topics