Switching

If I were to replace (25) 3560 switches, what Meraki model would you suggest for an enterprise environment. I'm looking for stacking switches with 48 PoE ports.

This seems like it should have been an easy fix, yet here I am. Our SNS, which we're using for authentication will randomly stop doing it's job, and users can no longer authenticate. I'm not able to reach the device at all. So upon checking the physi...

I'm a newbie, trying to setup telnet in my home lab to prepare for the CCNA exam. I've set IP on management vlan, set default gateway, configured  VTY lines 0 15, set transport input to all and verified all configurations.  How do I physically connec...

we have establish trunk link between two switches, at the port level, there are some commands configured: logging event trunk status udld port aggressive spanning-tree guard loop load-interval 20 can anyone explain what are the purpose of the above ...

Two Questions: 1. Does anyone know if when I perform a soft reset on the Cisco XPS-2200 it will disrupt network communications or disrupt power to connected switches, other network devices, etc., that are connected to the XPS-2200? In other words, ca...

Hello, I was wondering why the output from the 'sh inteface' command, underneath '5 minute output rate' is indented ? Is there any specific reason for this ?

Hi. When I log in remotely via SSH to a switch via laptop or another switch, after I enter the password connection freezes. It disconnects after 2-3 minutes. Anyone had this issue before? Any ideas? I cannot access this switch locally. Thank you

Hi everybody, Please consider the following example: R2--24.24.24.2---LDP--24.24.24.4- f1/0-R4 R2 and R4 has LDP neighbor relationship established, they also have TCP session established. Next, I apply ACL under f1/0 denying all TCP  incoming on R...

Hi, I just find some information from datasheet: Virtual output queue (VOQ) bufferMAC address entriesIPv4 entriesIPv6 entriesAdjacency entriesACLs Can someone tell me what main different or important point between N77-M348XP-23L and N77-F348XP-23?

I am planning to move couple of my VLan gateways from Cisco catalyst 6500 to Nexus. I anyone could suggest what to keep in mind before make any change in production ?

Good morning, I need some help because i have 2 switches 2960 and they are having issues to enter to enable mode, they actually are on a Radius server and the credentials works fine but when I try to enter enable mode the show a error it says % Erro...