Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Resolved! Qos on Switchport

I currently have the below configuration on a switch and switchport. M question... Question1:  If this port is connected to a server (no phone) should I remove the Qos settings on just this port? Question2: What happens with data only traffic with th...

Hi I have configured Auto QOS for the first time and just want to make sure I have done it right. I am using avaya phones (so enabled lldp) so my access switches have voice and data vlans on the access ports. The access switches are then trunked up t...

ello everybody, I have the following problem on a WS - C3850-12S . The log is always the following : % OSPF - 4 - FLOOD_WAR : Process 100 re - originates LSA ID 10.250.250.53 type - 2 adv - rtr 10.255.255.59 in area 0 The funny thing is that both ...

Resolved! VOIP phone VLAN

Hello, We have bought 2 VOIP phones to test with, one is by AudioCodes (420HD) the other is by Polycom (CX600). If I plug the AudioCodes and the phone goes onto VLAN 62 and the PC that connects off it is on VLAN 41, perfect.  However the Polycom st...

Andy White by Level 3
  • 2854 Views
  • 14 replies
  • 0 Helpful votes

Hello there!I am trying to limit bandwidth use using a traffic policing on a ASA firewall.Simply using the ASDM under Configuration > Firewall > Service Policy Rules I match for source and destination IP addresses (uses ACL), enable policing under Ru...

Hes by Level 1
  • 245 Views
  • 1 replies
  • 0 Helpful votes

Hello, We have a couple of SRW2024 switches that have quite some VLANs configured. We also have 7/24 work schedules... If I want to replace those switches would it be possible to save the configuration and import it into a newer model? Which one woul...

marcoesch by Level 1
  • 333 Views
  • 1 replies
  • 0 Helpful votes

Hello everyone ..i am a bit confused as how to use and implement dhcp snooping with ip souce guard and port security .. i have a scenario where i have around 50 L2 cisco 2960 switches all connected through thier trunks ans all tat end on a L3 3750x ...

Hi all, i m writing because i have a issue with configuring GRE tunnels on 3850.We use it to get traffic from a vrf to another building . We upgraded from a 3750X and were suprised that it should no longer be a feature supported !?!The 3850 also does...