Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi all, I am thinking of writing a program that will query the router (and switch) for the following information1) Model2) Platform serial number3) Any interface/modules connected and their serial numbers4) RAMI have 2 queries for this 1) Can i fetch...

Jonn cos by Level 4
  • 486 Views
  • 2 replies
  • 0 Helpful votes

                   Hello,I've configure the command below on a switch. when I try to telnet to it from a pc I get:PC>telnet 172.16.2.31Trying 172.16.2.31 ...Open[Connection to 172.16.2.31 closed by foreign host]PC>Command on switch:line vty 0 4passwo...

Hi,     I need to write  a parser for "show ip route"  from few routing tables that I have. I can not find on internet "show ip route" with all possible output which will help me make the parser work for even unseen data( protocol entries) in the fut...

I have an issue here with cabling, not sure what to do.  We are being handed off ethernet from our isp, it is a business only broadband connection and wherever the demarc is there is the ISP'S switch and the extension from the dmarc to our suite is a...

Hi All,Can you pls help with my question belowIF we look at the drawing below / attached the 6509 below the dotted lines are the Layer 3 engines with odd vlan as root bridge on one and even vlans as root bridge on the second one on those switch all p...

Dear All,If we configure a Voice and Data VLAn on a switch. And connect EX90 on voice VLAN and PCwith EX90 terminals. Than can we able to share a presenstation or data with EX90 or not?Best Regards,AR

We currently have Cisco WS-X6708-10GE blade installed in our Cisco 7606-S switch.  Each of the ports have a X2-10GB-SR tranciever.  When I look at the port with the "sh int tengig xx" command I see the following:!TenGigabitEthernet 4/1 is up, line pr...

dtom by Level 1
  • 890 Views
  • 4 replies
  • 0 Helpful votes

Hello,I was wondering what general steps might be taken in order to "replace two(2) 3750 (stacked) with one (1) 3750X - Server Access". General steps and what I might have to do configuration wise. I know i'm copy pasting the existing configs into th...

i am not getting ip add from the dhcp server ,if i am adding the dhcp server to vlan 50 then only i am getting ip addi am having two vlan 50 and vlan 51so can any one help me what is the isssue i am attaching my network diagram and configurationcore ...

Hiwe are implementing a new MPLS WAN design. The MPLS WAN design will use BGP.The first office to go will be Shelton.on our 1006 router that will be the Main Campus router(aggregation router for the remote site offices) we're going to configure BGP f...

Hi,has somebody found a way to disable the (time consuming) image download that takes place at the beginning of each switch replacement in Smart Install? As far as I see it even if the software version matches the version in the vstack config it is d...