Switching

I have 6500 core switch with 2500W power supply, and I want to install a second power supply with 3000W ? is this applicable ? if yes, is there a specific configuration that must be done ? ThanksBest Regards,Osama

We are seeing some "interesting" issues. We installed a pair of Nexus 7000's for our core and upgarded our distribution 4507s to 4507 R+Es.These are connected over 62.5 fiber using Ciscos 10G-LRMs. What I am seeing is link flap errors, but ONLY on th...

Hello,I have a question about vlan,I have one Cisco ASA 5505 Sec+ with Cisco Swith SG-300I create multiple vlan and I manage security vlan with Cisco ASA 5505 Sec+My question is : Is that all traffic must go with the Cisco ASA or all traffic go with ...

Hii have to provide internet connectivity to 4 usersfor person 1 i would like to porvide him a bandwidth of 4Mbps on interface gi0/4 of cisco 3560CG switchand the other 3 users need to provide a 1Mbps how to accomplish this can this be done on the sw...

Hello,I need to move our Dell backup server from our Nortel switches to our Cisco switches.  I have 2 stacks and I want to put one LAN cable in one of the Cisco stacks and one in the other Cisco stack, how shoudl I configure the 2 ports on the separa...

We have a bunch of switches that are running fine but the running-config file is missing and we can't save the config to the tftp server. Anyone else seen this? IOS is c3550-ipbasek9-mz.122-37.SE1. I've got lots of these switches running the same ...

Hello Cisco Experts,We are trying the BGP backdoor command...but this command requires we explicitly specify the prefix/route that the router learns via BGP which should be set as backdoor route when it is also being learnt via an IGP in conditions w...

Hi,Recently, I am having issues trying to combine two modules into one VDC. The modules are as mentioned below:IKN-6F-CoreN7k-SW02# show moduleMod    Ports          Module-Type                                               Model                      ...

Hello,Can someone explain the GLBP weighting option, I'm struggling with this one.  On my lab set up I have 3 routers and this is all working below, but want to practise using weighting.R1track 1 interface FastEthernet0/1 line-protocolinterface FastE...

I am getting this issue , when try to build etherchannel trunk in between this unit C4510 with the other C4506Physically can see that the slot 2 shows red light.  I had tried reinsert the line card of slot 2 still show same error below when show log,...