Switching

I am finding trouble getting static neighbor commands for EIGRP to work when I am studying in GNS3.My understanding is that all I need to do is type neighbor 192.168.1.1 ser0/0 in router configuration mode and as long as:1) Serial0/0 is part of the 1...

hi , from ccnp route cisco press book , the last of ipv6 tunneling i have a table Table 18-4      Comparing IPv6 Multipoint Tunnels                                Topic                                                             Automatic 6to4      ...

HiI just got my Cisco SG300 28, but I have some problems getting the routing to work. I get the vlans to get to the router, with the default route. But not getting them to talk with each other. I can ping the IPs from the cisco, but I am not getting ...

I have a customer with a 3750x4 stack. We rebooted the stack over the weekend and the master did not come back up. Upon investigation it was discovered that tghe master was set for Manual Boot. I tried issuing the "no boot manual" command in Global C...

HiI am seeing a strange situation on my 6500 switch which I am not able to understand and hence asking :). By having snmp walk on '1.3.6.1.4.1.9.9.109.1.1.1.1.3' (== cpmCPUTotal5sec), I came to know that there are two processor and the cpu util for s...

Hi AllWe have a pair of 6509-E with SUP 720 which constantly shows decently high CPU - 60-80 %... We arent sure what is driving this CPU ! Show proc cpu doesnt give any process which is consuming the cpu !  Initially we thought it could be due to RPF...

Could someone with Cisco IOS 12.4 Basic check to see if the command "ip nat pool" is available?We have 12.2 basic and I know it is in the 12.4 Advanced and 15.1 Basic versions (too large of a jump in version for management).  Our budget is very limit...

I have a catalyst 3560G switch that is having a hard time giving power to a Meru AP 320.  The following error is on the switch:010422: *Sep 25 16:53:48: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi0/1: Power Controller reports ...

hi ,i have the  topology below :"Vmware pc"<===="PC"<==========>switched 2960<=======>-Gi0/1-Routernote that:PC is the physical computer and inside it nother operating sysetm called "vmware pc" on router , we have an ip from vlan 1  on the physical i...

Hello, I have a hub and spoke WAN that conisits of one core location with with a 6500 and nine other buildings using 4006 Catalyst that conenct back to the core via dual gig fiber. We are using EIGRP at each location as well as the core.   I was tesi...

GRE Failover