Switching

I have 250 PC Clients which have as gateway a Cisco Layer 3 switch 3750 so i have change the Productive Server with new and change the ip address.Is there a command which make ip forwarding to new ip without need to change the connections properties ...

On a cisco ASA is it possible to load balance between 2 ISP links? Or is that not supported.Basically have an ASA load balance MPLS connections or is this not going to work and they have to use a router? meaning want both MPLS connections active for ...

Can someone verify my config, trying to deploy QoS not because we need it, as utilization of my uplink interface's are 2%, but someone told my boss to do so because they don't want to trouble shoot on the server side, i am running a 3750g switch. We ...

Good afternoon all,I have two 6509s both with single FWSMs running in transparent mode with bridged Inside and Outside VLANs.I have my Core A set to STP priority of 8192 and Core B set to 16,384 to make Core A the root for all VLANs.Problem I have is...

We have several remote sites  connecting to a central location. Each remote site has its own file and  print server hosted at the central location as virtual machines.  Recently, we've been having problems pulling data from one of these  servers (e.g...

hello all,i have a question..can we make PATtting to a host that is not in my subnet..i want to make a natting with SIP port number(5060) for a host that is not in my subnet..i have a cisco router and the host that i want to direct this SIP packets i...

Hello, folks.How filter inbound routes in Cisco ASA OSPF? Because Cisco ASA has no "distibute-list" command for OSFP process configuration, I try to use "filter-list" command in area definition. So, I try to use next configuration:R1 (Cisco 3660):ski...

Hello,I have 2 hosts, 1 plugged in fa 0/21 in VLAN 101 and another in fa 0/22 in VLAN 101 on our L2 Cisco 2960.  If I try and transfer files from either host the gig 0/1 trunk port on the 2960 leading tot he 3750 fa 0/1 port hits 100mb (using a real ...

I have 2 SMB SG 300-52 switches conneted via LAG (2 ports). My plan was to put all the users on one switch and the servers on the other. When I do this the communication is fine between the PCs and servers but its really slow to transfer files betwee...

I have a Sup32 that I suspect has faulty NVRAM (e.g., I am unable to "wr mem" on the device - it states resource is busy but no other active connections exist). Prior to replacing the supervisor engine I'd like to take a crack at formatting NVRAM to ...

Hi allI have multiple devices across my network that require sending SNMP traffic to a server. Currently this isn't working, and I suspect our cisco switches may be blocking SNMP traffic. I've started looking at the ACL's on the IOS config of the swi...

Does Cisco 1921-SEC/K9 support HWIC-4ESW ? I require 4 x 10/100 Ethernet ports If yes how many ? are there any drawbacks if i use this module instead of a switch?RegardsAakash.

Hi out thereI need to shut an incoming interface on an ASR if a "inside" trunk shuts - how can I do this? Is there a possibility trough ios.sh or how can I do this? We have a huge bunch of vpn routers I have to failover to another router if a link be...