Switching

HI,  Please find the topology below is it write config to use both link simultaneously... (TRAFFIC LOAD SHEARING)             RegardsSuhas

Have 101vlan for cisco management some deceives losing connect. When we move device port to another vlan the device stays up.Sent from Cisco Technical Support iPad App

I'm using the ctrl-break sequence in hyperterminal during the the initial boot, and it's hanging....any suggestions?thanks,A J

Hi allA quick question,I have some vmware sitting in my DMZ on plublic ip addresses, At the moment we have no management to them.I do not want to put the management addresses on public ip addresses so I dont have to waste them.is there any way around...

                   If a core and access switch have different etherchannel load balance methods, will the mismatch cause errors or performance issues?e.g Core src-dst-ipAccess src-mac

Greetings. I have  one specific trouble with Catalyst 3560CG switch and Stardom reserved industrial  controller. Controller has 2 processors, one of them after(!) negotiation become  main with IP 192.168.1.1, other one stays in reserve with IP 192.16...

I have an environment with Cisco 7941 phones and Dell Notebooks with port replicators.  When i undock a notebook and plug it in elsewhere in the network the MAC-Address Table entry does not age out and consequently the notebook is unusable due to con...

Urgent assistance is required.I have a requirement whereby a CCTV system is being installed that will need multicast RTSP configured on the switch network. I need assistance on how this will be achievable on 3750X IP Services switches? if this is not...

Hi, I have a WS-X6816-10G-2T module with X2-10GB-SR modules. I will be getting a SMF hand off and the length of the termination is around 100 meters. (I will be getting another hand off for Inter-DC link for which I have X2-10GB-LR module). The quest...

I wanted to know about EHWIC 8-Port configuration?  We create  Data and Voice VLANs and assign 8 ports to the VLANs. So how do VLANS communicate with each other? We cannot make Gi0/1 as sub interfaces and assign the same subnet IP’s as of VLAN IP’s ,...

Hello,Sorry if this is a dumb question but I'm new to the Nexus line of products. My issue is that I cannot get a 1 gig fiber link to a 3560 or 3750 to show up as connected after I upgraded my Nexus 3064 to the n3000-uk9.5.0.3.U2.2c NXOS. The 1 gig i...

HiI know that when the Cisco phoen gets the voip vlan it gets it using CDP from the switch, if the switch doesnt use CDP then how can the phone get the voip vlan, I know you can do it manually but can you get the phone to learn its vlan via DHCP opti...