Switching

Hi AllI have trawled through the Cisco website and am struggle to find the answers to the below question, is any able to helpDo the Cisco 2960 and 2960S      series switches support 802.1X-2004? Cisco 2960, is there a planned end of sale for these s...

          Hi         On a Cisco 3560 with IP services ver. 12.2(35)SE5 I have tried to config BGP with a 6-digit AS number, and it is not possible. Is there someone who knows what software is needed for 6 digit AS number for PI IP addresses, and do I...

Hi all, This question may be bit OT to this forum but i need some suggestions on it. We are planning to deploy SSL based solution that will provide customers access to our portal. We are planning to use 2 different ISPs for redundancy purpose, so i a...

On our edge router the CPU utilisation was quite high. On checking further we could see that the broadcast on the LAN interface was quite high. - Not sure if this can cause high CPU usage?Interestingly the broadcast count in sh ip traffic result does...

Hia simple question, please advice me if I have 500 equipment, and I want a monitoring server use ether snmp/cdp to monitoring systems,which one will be better, and cause less perfermence issue, and less traffic issue.Any comments will be appreciated...

Hi all. Im having a strange problem on a 6509 switch. I am trying to use a Tekradius Windows2008 server to aaa authenticate switch admin logins. The Radius server and 6509 loop0 are in a management VRF "netman". I can happily ping to and from the Ser...

I am finding trouble getting static neighbor commands for EIGRP to work when I am studying in GNS3.My understanding is that all I need to do is type neighbor 192.168.1.1 ser0/0 in router configuration mode and as long as:1) Serial0/0 is part of the 1...

hi , from ccnp route cisco press book , the last of ipv6 tunneling i have a table Table 18-4      Comparing IPv6 Multipoint Tunnels                                Topic                                                             Automatic 6to4      ...

HiI just got my Cisco SG300 28, but I have some problems getting the routing to work. I get the vlans to get to the router, with the default route. But not getting them to talk with each other. I can ping the IPs from the cisco, but I am not getting ...

I have a customer with a 3750x4 stack. We rebooted the stack over the weekend and the master did not come back up. Upon investigation it was discovered that tghe master was set for Manual Boot. I tried issuing the "no boot manual" command in Global C...

HiI am seeing a strange situation on my 6500 switch which I am not able to understand and hence asking :). By having snmp walk on '1.3.6.1.4.1.9.9.109.1.1.1.1.3' (== cpmCPUTotal5sec), I came to know that there are two processor and the cpu util for s...