Switching

Aloha All,I never was sure if you could do this.  I did a little digging but failed to find a yes no answer yet.  Here is my config:ip http serverno ip http secure-serverip nat translation timeout 60ip nat pool rolloffs 999.129.10.250 66.129.10.250 n...

Hi,I have two CSM (active/standby), if reset CSM active, current session on active will lost? I'm not sure about replicate csrp sticky and connection will help or not. Thank you for all feedbackSome configuration... vserver CFI-8443  virtual 10.108.5...

i have an 1841.it loads up from the external CF.lost the password.when the CF is out it boots to rommon>cant dir the flash:rommon 18 > dir flash:dir: cannot open device "flash:"usb fla cant be read either.i followed conreg instructions for changing t...

Hi,I hope someone can assist, I am trying to connect a SG 300-28P connecting to 1761 with HWIC-1GE-SFP by fibre the physical link is up but I can't get any traffic through on my default vlan 1.I have added this to the router:interface GigabitEthernet...

Is it a fair enough and accurate statement to say that STP should never be turned off on switches in a L2 domain, even if a loop-free topology is deployed.

I recently received a C1921 and am doing some lab testing. I am trying to apply some old configs from a 2811 but some commands are not working.The most annoying to start is the ipv6 address family in a vrf definition (multi-vrf/VRF-lite). There is no...

Is there a way to determine the reason(s) of latency in the network?We use Cacti and IP SLA for end-to-end performance measurements using ICMP and this works fine, however we would like to investigate the potential causes of latency along with sugges...

According to the Cisco Download Software selector for the 4500 SupIV and 4948s, 12.2.53-SG4 is identified as GD code, "12.2.53-SG4(GD)".I've never seen GD code released for a Cat4500Sup4.  I do not find GD or General Deployment mentioned in the relea...

I'd like to convert my XenPak ports in a 4 port 6509 blade to SFP+Will the ONeX converter work for this purpose?   Or is it only for X2's?   Is there really a big difference?Converter part is CVR-X2-SFP10G=Blade part is WS-X6704-10GEIf the converter ...

Hi, When I tried copying  an IOS image from one router to another router through VPN Tunnle I found few dots while copying, and when I tried copying IOS image from one router to another switch using P2P link, I found few Circles while transfer.Howeve...

We need to discover what is connected to hundereds of switches and the customer has poor documentation. They are running CiscoWorks. Can CiscoWorks generate reports to show what is connected to each of the switches it is managing?.

Hi,My 877 is not renewing the DHCP lease on the BVI interface, end result is that it shuts down the interface every four hours and does a broadcast for a IP, it get's the new IP and activates the interface.My interface configurations for the ATM and ...

I need to create a vlan from a port on a 3550 (vlan100) to fa0/0/1 port on a ESW on a 2811.  What is the best way of going about this.  The interface fa0/0/1 on the 2811 never wants to come up.