Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi there,I have an issue with a Cisco 3825 router. When I try to save the running config it shows a paticular error. This same error is displayed when I run the SH START command. Router#sh startUsing 1826 out of 491512 bytes%Error opening nvram:/sta...

Dear All,I have CAT 6500 switch Is it possible to include the ACL for extended TEST access-listinterface Vlan10 description [Test] ip address 10.0.0.1 255.255.255.0 ip access-group TEST in no ip redirects no ip mroute-cache ip ospf cost 1 ip ospf pri...

Hi, I have this question:Our customer performed an upgrade of IOS on Cisco 7613, after the automatic reboot, they received this messages by console:belong to this routing instance.% Interface Serial4/2/7:1 does not belong to this routing instance.% I...

Hi there,I have setup a DHCP server on cisco 3750 switch and it works perfectly fine except lease time, it looks like it never reuse ip address if it was assignt before:My config belowip dhcp pool IT_WORKSTATION_DHCP   network 172.21.133.0 255.255.25...

HiCurrent scenarioSite A - switch A fibre connectivity between A and BSite B - Switch B fibre connectivty between B and CSite C - Switch CSwitch A is connected to switch B through fibre port-Switch B is connected to switch C through fibrethere are so...

HiWe were using a 6504 with a  10 gbyte link on a local carrierAll was working.I enabled VSS and suddenly it ceased working.We had VSS working across a different link no problem.We were using this IOS -s72033-ipservicesk9_wan-mz.122-33.SXI4aBut down ...

Hello,I have one question about with this theme.Imagine a connection between a router and a switch with 2 vlans. In all instalations that I made, I always create the vlans on both router and switch and the connections between the 2 equipments are mad...

This is a generic issue, although I'll use a specific example to illustrate my question:When booting an IOS box into a new config, the console will display error messages for lines it doesn't like.  But it doesn't give a lot of clues as to *which* li...