Switching

I think I may have found the correct forum here. Been trying forever to make good use of the router I purchased from Cisco market during CCNA class.(871w) I wiped the initial config , thinking I was good enough to do it by commands. Slick , huh? Wel...

Hi,I have connected a Cisco 857 router to an ADSL line. Internet worked for a while, then the connection started dropping. I have tested with a different router (a Netgear) and the connection is stable. The line is adsl 2+, and I have loaded the lat...

Hi I have a cisco ASA 5505, and we have one ADSL internet connection and 1 leased line to the internet. I would like to connect both of these circuits to the ASA and also have a DMZ VLAN. The Inside Lan address will be directly connected to a Micro...

Can you weight WCCP so that if you have two devices that web packets can be sent to (Proxy servers), it will favor one over the other unless the primary fails.

All,I have a situation where I don't want a default gateway unless an interface is down. The default gateway is still getting put into the table even though I'm tracking based on this interface:router# sh trackTrack 1 Interface FastEthernet0/0 line-...

Hi Everyone,Would like to ask if anybody knows how to use reverse telnet in a Cisco 3845 router. Appreciate any help.Thanks much!

Hi all.please help!i have a problem. i don't known command to enable Spanning tree portfast on Switch Cat2948G. please see information about IOS verison and Platform of device?

I am configuring a 2600 series router to run Security device manager and when I put in the commands "ip http secure-server"and "transport input telnet ssh" they don't work. I am in global config mode.

I'm hoping some can critique a very basic redundant ASA configuration. Currently, we have rackspace at our provider. The provider provides us two uplinks to their cores. I have one ASA5520 and one 3560 switch, so both uplinks (fiber) are on the same ...

hi all. I am confused with the following issue pls guide me. I have defined this aclaccess-list 113 per icmp host 10.0.0.1 host 10.0.0.2 echo tos 3 logaccess-list 113 per ip an anNow from R1(10.0.0.1) i did an extended ping to R2(10.0.0.2) setting TO...

Dear Expert, I have Cisco 877 series Router, this type of router has 1 ADSL WAN port and 4 Ethernet LAN ports. The device will be connecting into the SHDSL circuit. It cannot use the ADSL WAN port since the SHDSL circuit is using Ethernet ports. Inst...

1)What is difference between Router and Layer 3 switch?2) What is difference between Layer 3 and Layer 2 switch?Contact Detail Dinesh chavan (CCNA & Firewall Specialist )Email ID dinchavan11@yahoo.com\dinchavan11@gmail.com

I'm in the process of implementing QoS on our network...I've already been using it on our Edge routers and that's working pretty well. However I'm having some issues doing it on the LAN, specifically on our 3750's. To start I'm just trying to mark ...

Is there any specific show command to find out the interfaces which logging event (logging event link-status) enabled except sh run && sh run int.