Switching

Dear guys,as far as I read only port up/downs can trigger TCNs.I have got 4 switches connected to each other.The direct link to the root bridge breaks down. The other switch (switch2) now asumesitself as root. I guess that's the reason why it does no...

Dear all.We Are palnning to Modify the Switch connectivity as given in the attachment.Need some comment on this and will it be ok to work with this setup.

I have a cisco ME-C3750-24TE and bought a license ME3750-IPSVC-LIC=How can I check if the license is active in the 3750?Thanks

hi, any one tel me the software free one or trial version which is using SNMP traps to dram automatic topology diagram. Thanks Thina.

All,I am working on getting a Cisco 2500 router working with a Linux router (IPcop) that is my gateway out to the Internet. My network topology is attached in .png format. Essentially, I have the IPCop Linux router connected to a D-Link layer 2 gigab...

Initial setup with Router2 connected to the cable modem with WAN=56.xx.xx.xx worked well. When second RVS router, Router1, introduced for an ecommerce application, communication between the routers does not work. Also, the 192.168.1.0 subnet is not...

If probe fails for a rserver what will ACE do with the current connections

I was playing with reverse routing and noticed the following behaviors1)it can't deal with permit ip any any? Exact From subnet --> To subnet required2)the created static routes are not the same as usual static routes? see belowSPOKE -- HUB1 | | HUB2...

Hi,I have the following topology :VoIP application (H.248) is running over a topology that is connected to a Router in Port 1 .Port 2 of the Router is connecetd to the softswitch.The question is how to configure the Router in such a way that the app...

Hello,I have one l3 switch. I want to create multiple Vlans on it but at the same time the Gateways for those vlans are different. This is what is my current config :ip default-gateway 192.168.0.1 vlan 3ip address 192.168.0.2 255.255.255.0untagged 1-...

HiCan you please tell me a command to find out which routes are being advertised by a neighbour?ThanksDan

Is there a command to verify the QOS markings and trust settings on a 6500? I am trying to verify if packets are being marked based on the trust settings. There is no external sniffer. Thanks