Forum Posts
does etherchannel cause multicast packets to be received out of sequence, gapping, duplicate..etc ??? in general, would etherchannel affect multicast traffic ?
Dear Sir,I have problem with the C9200 log discriminator setting. It seems the length of the paramter is liminted to 40 characters.Could you tell me what can I do if I want to filter additional messages ? This is the current setting , the character h...
Good Day,I am current having issue whereby the macsec is not working between 9500 cisco 17.x.x on Layer 2. I used the below configsmka policy (name)macsec-cipher-suite gcm-aes-256exikey chain (***) macseckey 1000cryptographic-algorithm aes-256-cmacke...
How to configure span port on CBS250-8P-E-2G
. The requirementsof this design are summarized as follows:• The building has three floors.• There are 300 user workstations and 10 servers.• Users must be grouped according to the projects they’re working on, but the users foreach project are locate...
I have a stack of two 3850's configured with an int vlan 17 and we access that switch via an IP on that vlan. However, I configured a new vlan 777, and with that new vlan I can ping out but can't ping it from outside other networks/subnets/devices. T...
Dear Cisco Community Team,I would like some help and guidance on fixing an issue I have with 2 Cisco 6513 switches.The 2 Cisco 6513 switches are working as my data center switches connecting most of our systems to it.The CPU have been spiking multipl...
Hi all,Do we know how often the output of the show command "show power" is updated ? What is the time interval that is used to update the results ?
Resolved! CISCO 881 Port security
Was wondering how to set port security on the 881. I have all the FE ports shutdown except one and want to limit that port to one specific MAC address. Thanks,Dave
Resolved! nexus vpc is down
Hi,I confirmed VPC in two Nexus switches and PVC peer-Link is down.Is there any issue with the configuration.sw-secondaryvrf context managementvpc domain 10role priority 10peer-keepalive destination 192.168.1.1 source 192.168.1.2interface port-channe...
Hi all; Cisco newby, but I am managing pretty good so far. However, I do need a little direction on this one. I am implementing a Watchguard "FireCluster" in an Active/Active configuration. From the Watchguard doc's, they say the following: ""All swi...
i am deploying a 3rd party nac solution with a cisco sg250 10port switchon the gui interface of the cisco sg250 switch i see 802.1x configuration which was properly configuredhowever when a user connects to the interface of the switch for 802.1x, on ...
Hi AllThere are 4 switches in the DC, 3 switches are configured as MST and by mistake one switch is PVST. This is causing an issue now so am looking to change that one PVST switch to MST. All switches are L2, the PVST switch has got only 10 L2 vlans ...
