Switching

Hi All,What exactly is "steady state" what is the Power consumption of a 3560G-TS in steady state (ie not actively providing power to a attached switch) Thanks,Matt.

Hi I have to paths to our data center. I would like to increase the path cost of the secondary link so that the primary link will be used for Vlan 1.

HiI've got a switch with about 70 vlan's and 3 loopback interfaces on it, the switch also does routing. I want to telnet to a device on vlan 66, how do I know what ip the switch is going to use as the source ip address if I initiate the telnet from t...

Is there any link on CCO where it can walk through detailed steps with configurations and commands of Cisco Nexus Switching platform?

(When running rstp) from "sh spanning tree" output , does anyone have a list to show the meaning of each of the "Type" i.e. P2p, edge peer, etc.I have searched for a definitive breakdown but so far nothign truly definitive. Thanks

Hi all. I'm not sure my question is right addressed in "Network Infrastructure" channel, so please eventually redirect me to the right channel. Question: we want to know if the CiscoView 6.1.2 component of the CiscoWorks (LMS2.5) software support the...

I read (for BSCI exam)when each router receives the LSU and the entry already exists but the LSA have a higher sequence number the router adds the entry to its LSDB.My question is why router adds this LSA that already exists (it was duplicated), why ...

why when I'm use the 2960-24TT-L as bridge between primary switch and my PC take these actionblock my PC interface . until I,m use this command #no span-tree vlan 1 on the 2960note : the primary switch 3com

Is there a specific reason why i'm not able, in CLI or web interface, to manage any of the trunk ports 21st to 24th ? We're plugged to a IAP's router which is configured 10mb full and the port is giving me Half-duplex. I can't change it from Auto, i ...

Hi @all, there's something I don't understand. We have an ASA5520. We also have some wireless LANs. The clients of the one wireless lan (wlangaeste) are natted to an ip address (x.x.x.x) behind the outside interface. That's working fine. But the clie...

hi all. Kindly consider my following access-list that i want to apply on my branch routeraccess-list 111 per ip ho 10.1.56.1 host 10.1.4.56access-list 111 per ip ho 10.1.56.2 host 10.1.3.6access-list per ip ho 10.1.56.9 host 10.1.47.69Now this should...

Hi there:I have several pieces of Sup2 engines, recently i want to use them for testing purpose, and i found this message every time i power cycle the switch.----------------------------Warning: Rommon NVRAM area is corrupted. Initialize the area to ...