Switching

Hello,I recieved this log message today on my 7206 that confuses me. The message itself makes sense, but there were no log messages being generated that would have caused this output.I have gotten this message before, but I thought it was related to ...

the module no. 9 on 6513 has this error Mod Online Diag Status ---- ------------------- 1 Pass 2 Pass 7 Pass 9 Minor Error 10 Passand after reset it , it gives these errors,Apr 14 09:15:05.169 GMT: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module ...

hi,I've done this in the past, but can't get it to work this time. I all want to to is show on the configure monitor session of a router I have a telnet session with, is the denied logs as an when they happen.On my extended access list I have added ...

Just recently upgraded on of my branch offices from a Sup1a to a Sup32. In the last 2 weeks they have experienced 2 small outages lasting abour 4 to 6 mins. each. During the outage, connectivity was lost to all server and remote locations as well. ...

HiI have one Cisco 6513 Switch Installed with FWSM module. I have another 6513 Switch with FWSM Module. Both hardware are perfectly working. I am trying to configure redundancy between the two switches and FWSM. It is also working perfectly. When I s...

I have Linux host with a XP VM running on it. On the XP VM i have a Cisco VPN client that users use to connect to remote servers. Once the user logs onto the XP VM and uses the Cisco VPN, they loose connection to the VM. Anyone know what can be done ...

In firewalls or in routers, if we ping is blocked using icmp..which disallows ping responses.But doesnt traceroute use icmp as well,so shouldnt blocking icmp disallow traceroute also or is it blocked by using ports above 64000 range?In a case, trace ...

can anybody tell me following :sh loggSyslog logging: enabled (0 messages dropped, 15568 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled) Console logging: level critical, 1007 messages logged, xml disabled, ...

Hello all,I'm having an issue with my PIX506e.I have a 15M/2M connection to my ISP but my download speeds are only 3M and my upload speeds are only 1M once I installed my PIX. I tried resetting to factory defaults and all that jazz. I hope there isn'...

Hi, I wonder if you can help me, I am getting this error on both my edge switches - 10 16:09:04: %SW_MATM-4-MACFLAP_NOTIF: Host 000e.d771.089e in vlan 12 is flapping between port Gi1/0/23 and port Gi1/0/25 - see below.Both switches are connected toge...

Hello ExpertsMy home broadband has just been upgraded to ADSL2 and my cisco 857 doesn't recognise the ADSL line anymore.Its got 12.4(6). The wan interface is reads ATMoPOTS.Some forums say that the Firmware needs upgrading. Some say the IOS needs upg...

Is it possible to define only this range of hosts: 192.168.80.200-254 /24 in standard ACL without entering each host per line?Thank you.ip access-list standard PAT permit 192.168.80.200 permit 192.168.80.201.. permit 192.168.80.254Any other ways?