Hi all,I am trying to get out to the Internet using a PC that routes through two separate networks (10.1.13.0, 162.105.72.0) and it is not happening. Here is my setup.Edge Router = 162.105.72.1/24LAN Router G0/0 = 162.105.72.14/24LAN Router G0/1 = 1...
Hello Please if, I use more than one interface for a unique mac adresse in the command ""mac-address-table static"", in this case, the switch will use the first interface declared or it will forward the frame to the all interfaces configured ?? thank...
Hi, We have two Internet connectivity in our office. One is through Leased line and other through Business ADSL line. Right now we are routing the Internet traffic manually for some of the vlans through ADSL and some are through Leased line.with out ...
i hav the following setup in design stage..i need to analyse the viability & best options for then/w.It has 2 PE's(metro-e) from different providers over MPLS cloud, corresponding CE's at our end hooked upto a L3 6500series.Cloud is running BGP , i w...
In using the "switchport trunk allowed vlan 1,2,3" command, to add a vlan to the existing list of vlans allowed, will I cause spanning tree to re-converge?I'm pretty sure it wont but I have no way to lab this before a change control that I'd like to ...
Hi allon router cisco CISCO7606 (R7000) processor (revision 1.0) with 227328K/34816K bytes of memory.Processor board ID FOX0838006QR7000 CPU at 300Mhz, Implementation 0x27, Rev 3.3, 256KB L2, 1024KB L3 CacheLast reset from power-onX.25 software, Vers...
Any easy way to find the root bridge? have 6513, 6509, several 2950's and 2948G's. I know of the show spantree Summary etc. But I have no idea what mac address being returned goes to what switch.what is cmd to get the mac of switch with CatOS and Ca...
Most of my switches are running 12.2.25 or later. That version is capable of running Rapid Spanning Tree (802.1w). The show run says "spanning-tree mode pvst", and the show spanning-tree vlan 1 says "Spanning tree enabled protocol ieee". I have n...
4006 ios 12I configured a port to be trunk and allowed 4 vlans. Now the port is in a "down" state. I've entered the command "no shut" with no luck. I also tried "shut" followed by "no shut."What I am missing?
HiI'm doing nat for the first time on a 6500 switch and I'm having problem with getting the configuration working and would appreciate some help.I've got the following:vlan 10ip address 10.45.10.3 255.255.255.0standby 10 10.45.10.1ip nat insidevlan 2...
If I try to enable vPC on N7k, this message appear:"vPC enable status: Incompatible hardware not enabling vPC"What does it mean? NX-OS & EPLD version 4.1(3)
All,I had updated the IOS on the new switch before adding it to the stack this weekend. After adding it to the stack, I looked at the stack and noticed that the new switch had a version mismatch. To "fix" this, I deleted the IOS folder in flash on th...
All,I've NEVER used an acl in the outbound direction. Can someone explain what the benefits are to doing this?Suppose I have a web server in a DMZ addressed as 192.168.1.50. I could have an acl like:permit tcp any host 192.168.1.50deny ip any anyI co...
