Switching

Hi,Can I get a summary of what ports are inuse on a Cisco 2650 switch?Thanks

I shutted down the GigabitEthernet-I/F on a cisco3845-router. The Link-LED stay on. Shouldn`t the Link-LED went off when the Interface is Administratly down?The other side off the Cable is connected to a Catalyst. Does anybody have a expaination for ...

Hi! I need to know the uptime of a module installed in CAT6509 running IOS. Is there a command to view that?Thanks

I have some switchs Cisco and I would like to find an IP address on the LAN.I want trace and IP address or a MAC addressI would like to find the out-port of the switch where the computer is connected.I know I can use the command sh mac addr dyn | inc...

Hi Guys, i got 1 question regarding question. i was just wondering if anyone can help me in answering it. I have a frame-relay link lets say 1 mb. i wanna configure qos and for some application lets say for example telnet. i wanna guarantee banwdith ...

I've setup a Cisco 3750 & 3560 with VLAN20 & VLAN30. Is it by default that VLAN20 & VLAN30 are isolated i.e. users on VLAN20 are not able to view VLAN30 files & folders ?If no, hope I can get some samples to secure the VLANs.regards,

Hi Experts,I have one HP-switch was getting reboot and the users are getting so much inconveniency. So the challenge is I have to resolve this issue with in early stage.So Experts can anybody please investigate the firmaware version of this switch an...

I have a connection to a BRAS setup that needs stacked VLANs, 660.1 to 660.10I'm not connecting to the BRAS yet, as I'm first trying to sort out the appropriate config.So what I'm doing is I have 2 PCs one running wireshark and another one starting t...

Hello,This is my first post so please forgive my poor english ...We have a ISR 2851 + NME-16ES-1G with per-vlan subinterfaces defined at the router level.The Gigabit internal link is used as a trunk between these subinterfaces and the network module ...

Hi all,I have requirement to access two vlan from my PC.I have configred the LAN switch(cisco 2960G) as trun port,In my NIC intel 82566-dm2 gigabit ethernet card configured two vlans.But it is not working..If any setting to be done on the switch apa...

Layer 2 is up, but can't ping even a directly connected interface from HP Procurve 10GE port to Cisco 10GE port.

Hi All,i am using Cisco 12000 router with 3GE-GBIC-SC module on the same. Since I am unable to do dot1q in dot1q, can any one suggest me if this module support this feature or not?Thanks and RegardsMangesh A. Bhende

HII am trying to run Layer3 with LACP Port-channels from C6k--L3(lacp)--JuniperEX4200 running ospf. It comes up in EXSTART state so deb ip osp adj and see Juniper sending mtu of 1482. Since 1482 is not support on Cisco, I hard-code mtu on both Cisco ...

Hi NetPro,does anyone knwo this ?Error-1-Console> sh test 1Diagnostic mode: complete (mode at next reset: complete)Diagnostic failure action for SUP: offline (mode at next reset: offline)Module 1 : 2-port 1000BaseX SupervisorNetwork Management Pr...