Switching

I'm trying to mapp out a network and I have a catalyst switch I need to access. The only information I have is that it is not ip addressed. It is accessed through port 49 VL220 I have the password but don't know how to interface with it with out a ...

With the following:interface Loopback0 ip address 192.168.199.1 255.255.255.0interface Vlan1 description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$ES_LAN$$FW_INSIDE$ ip address 10.0.0.254 255.255.255.0interface Virtual-Template1 type tunnel tunnel mode i...

I have a c3524 xl that out company no longer has the password for that I need to start over with. How to I take the switch back to default so I can reconfigure it.

Guys,We have 2 CoreSwitches 6509 one is already configured and activated. Our goal now is to run and activate the second CoreSwitch and implement the HSRP/Redundancy. So in case the active CoreSwitch (Primary) is down the secondary will be up.Any con...

Hi to all,We have six Catalyst 2950 switches. We would like to install a Backbone switch for these switches.Which device do you think that would be the most appropiate? Maybe a 3750 switch would be enough?Thanks.

We have 2821 router and I have added VWIC2-@MFT-T1/E1 card. I am unable to see it in the config. I did try adding the command card type T1 1 0. i do see the cardin the show ver. Thanks

We enabled VTP and started using it shortly after our new infrastructure was put in-approx 1-1/2 years ago. However we did not enable pruning.Would enabling in now cause any problems. We have approx 25 VLans that really at this point aren't being u...

If my ISP gave me: 24.24.12.138 / 255.255.255.248 - giving me a range of 24.24.12.138 - 24.24.12.142In order to get mutliple IP's to work on an 871w. Would I?Interface FastEthernet 4ip adddress 24.24.12.138 255.255.255.248ip address 24.24.12....

This is a stupid question, but I dont have time to research....Is "serial 2/7:0" a physical or logical interface? I believe it is physical, but the ":" always throws me for a loop...been a while since I messed with this type of serial card.ThanksVL

This is a bit out of the norm, but I think this could become a fantastic resource of real world experience. Please, just follow along and throw in your twenty-five cents worth.Everyone, listen up. In your own words. In YOUR hands on experience, wh...

How can I make the log to show the correct time? I have set the clock on the devices but the sh log still show a wrong time (23w0d). see below23w0d: %SW_MATM-4-MACFLAP_NOTIF: Host 001c.2303.300d in vlan 10 is flapping between port Gi1/0/41 and port G...

As per diagram attached, what would be the best way to get spanning tree configured (root bridge cost, link, port cost, VLAN's cost...)Network performance is my main concern. Thank you in advance.Trbonja

I have cisco 4507R L3 switch having IOS 12.2(20)EW.I am not able to create Subinterface on fastehernet port.Is it possible? or is there any specific IOS required?