Switching

Hii have 3 Cisco Catalyst 2950 stackable and i want to stack these switches and set one ip address on these 3 switche . can i do set up 1 ip address on 3 switches or must each switche have one ip address ?thanks

hi all, can some 1 explain me the difference between layer 3 and 2 etherchannel ? ( kindly also refer me a cisco doc also ), and suppose i have 1841 router with 2 fastethernet interfaces then can i make a layer 3 etherchannel based on these 2 interfa...

Hi someone can help me to troubleshoot this NTP case:I have Linux NTP server and i try to sync time with my cat6509 but it's not work? I'm not sure i miss something, here this is config of cat6509ntp clock-period 17180022ntp source gig 5/1ntp master ...

HelloI am trying to get some expertise on logging SLB on my 6509. We are working with law enforcement in a child pornography case. I have IIS logs that show the accesses made to our web servers but because we utilize SLB the source IP address is al...

Hi, I need to copy a directory with all subdirectories from an access point (AP)to one of my local machine. The problem is that I can copy only one file at a time. I can't find how to copy the whole directory or how to archive it first on the AP and ...

Hello experts, need your insights on this oneI need to break broadcasts in my company's LANCan a LINKSYS router [which i believe is more of a switch though never used 1 b4] do this or should I get a Cisco router?

I have two switches, switch1 and switch2, plugged into each other with a layer2 trunk link. I also have a 3rd switch, switch3, plugged into both those switches with a L3 link, all switches are running eigrp.My question is, I've set up a /32 address ...

Hey, Within the next few weeks i'll be setting up trunking between my Switches and to the Router to work with ROAS. I'll also be looking into routing between VLANS but i dont have enough machines to stick in each VLAN to ping and test. I know of the ...

Is there any emulator utility for Cisco Switches as Dynagen for Cisco Routers? Moreover such utility(if there is) runs on Windows Plateform, i hope that anyone have knowledge about it..

I need to create a new setup using cisco 3750 switches. They will replace 2950 switches which are cascaded using GBIC ports. Need I connect the 3750 switches using stack cables. And in this case therewon't be any requirement to use 10/100 ports to ca...

Dear,I tried to make simple configuration for SOHO with Cisco 1841.Problem is that I Can't access static NATed host from local segement(192.168.1.n)with x.y.z.3(global address). Target host is located in the same segment(192.168.1.n).However, I can a...

Hi all,First post here so please be gentle :-)I'm looking for a bit of advice with a LAN setup I've been tasked with.The basic requirements are to have a demonstration suite of servers/storage devices networked with internet access with certain devic...

Hi there, i have 2 switches, a 2960 and a 3750 connected with trunk links. In the 3750 switch i have the native vlan tagging on. On 2960 i was told by cisco personnel that i doesn't support native vlan tagging. Though, i have placed a sniffer on the ...