Switching

dear sir, We tried to delete off vlan 250 on the network by conf t --> no inter vlan 250 and no vlan 250 . However we did a show vlan counters as below, we still saw the vlan 250 is there. But with show vlan, we won't saw vlan 250 there. Vlan 250 ...

We have problem that we have two switches 2960 and 2950 both with GLC-FE-100FX= modules. But they are unable to communitcate. can anyone help in this regard.

What are VLAN throttles ? When does this occur ?

I am trying to upgrade a 3750-24PS. No matter what image I try to upload I get a error when booting.flash:/<IMAGE_NAME> magic number mismatch: bad mzip file.I have tried every single 12.2(25) image I can find on CCO and they all return the same error...

I would like to know the Layer 3 performance of a 3750-E switch.Is this more or less the same as the throughput in Mpps since CEF is being used?

Does anyone know a model of switch that is all fibre LC connectors?I am looking for somthing to connect fibre switches to that are currently on media converters.

Hi,we have internet line from bharti and we want to terminate on layer 3 switch.what configertation will need to be done.

Hi all, suppose i have 10 neighbours configured in bgp process of RA, now i want to advertise network 25.0.0.0/8 to only neighbour 12.0.0.1 in the same AS, i want to do it using the minimal set of commands, how can i do that ?? i dont want to adverti...

Hello,I want to ask if there is a possibility to create manual or automatic (configuration ) traps on a 6509/6513. The questions is regarding to Network Monitoring with NNM and OVO. Need to see if manual generated traps are being showed up on these t...

Hi!What I do like to load, with a command line only, a configuration stored on an ftp server or tftp. What my advice? We need to know because I am developing an application that will allow me to load jsp through commands rcp rsh or any configuration ...

Hi @ allI think,it is a easy question.Is it possible to start a reverse telnet session over the aux port from a Cisco 2821 Router to a Console Port from a Non-Cisco Device (for Example a Lantronix Console Server)???If yes, which parameters are necess...