Switching

My customer used the 7609 with QoS configuration.but the customer had to configure on 7206 with 7609's QoS configurationbut the system performance was poorIn my thinking, It must be a system performace issue. but I give a back data to my customer lik...

We have just bought a new site adjacent to our current site and need to bring it onto our network. We currently have 1 subnet at present so no routers. The new subnet will host up to 50 users. Most servers will stay on the original site so there will...

HiI've got a Cisco 3660 which doesn't show installed NMs when 'show diag' is issued. It has a NM-1FE2W & a NM-4T installed.sh diag, sh diag 0, sh diag 1 & sh diag 2 all show the same thing.sh diag:3660 Chassis type: ENTERPRISE3660 Backplane EEPROM: ...

Right at the end of the ICND1 Cisco book and nearly ready for the exam but I have a few areas which need ironing out. One of those is RIP2 and Autosummarization/Manual Summarization. According to Cisco, when enabling RIP2 on a router, only classful n...

Hi All,One of our 4507Rs is periodically reloading but it does not give any clue as to why, for example there are no chrashdump files and the sh ver output states that the reason was down to a reload. We've tried upgrading the firmware to no avail (o...

Hello,There is a "show running-config all" command, which allow you to see default parameters of all features on ASA/PixDoes the Cisco IOS have the similar command?

Hi,I use Cisco 850 router as DHCP server. When I set IP address in some client PC manually I can't access the router (no response to ping, no response to telnet session, etc.), when address is set via DHCP, router responses. The same behavior is when...

I have been asked to investigate spanning tree on a customer environmant. They are using a colapsed core with two 6509 switches (hybrid mode) connected to aprox 40 access switches of different models.I need to find out which vlans are assigned to ea...

I have nat setup as below.ip nat inside source static tcp 10.0.0.25 443 interface FastEthernet0 443Fastethernet0 (ip nat outside)It works fine from internet trying to https://somedomain.com. But it doesnot work for internal users trying to https://so...

Can someone help in configuring the internal Cisco CIGESM modules of an IBM BladeCenter H (BladeCenter H Type MT8852 Product ID: 88524XU. With two each internal Cisco CIGESM modules, 20 port network switches; (16 ports (one for each blade) + 4 extern...

I have just found out that GRE tunnels are not supported on 3750 switches so I need a 2800 router, but how do I find out the correct IOS version to support tunnels?