Switching

Hi,I have two 512 kbps of link from same ISP and both link were terminated on same router. I have different LAN/WAN pool for both ISP. M using nat on same router but want to do load sharing on both link.How it is possible.Pls help me out, Thanks ..

Hi all, just a quick question, If I route from router a to another router (router b) which has the destination network on one of its interfaces, but router b has a route saying all traffic destined locally route to another router on the same subnet, ...

I have configured my 857w via combination of the SDM and CLI.As it stands I have two issues:1.Unable to obtain DHCP address over WLAN2. MSN messenger is unable to connect.Attached is my config.I would be grateful if someone could point me in the rig...

Hi all, can anyone tell if when using asa firewalls, do they verify the reverse address using dns when connections sourced from outside are being made? I have seen this on other firewall vendors, is this standard firewall practice ?cheers

Team,I have configured port-channel88 on catalyst 6509-E switch but when i tried to configure the this channel on tengigabit interface getting the following error message. ***************************************ERROR MESSAGE**************************...

Hi guys, What is the correct way to determine the memory of a cat6500 running native IOS (sup720)?I see something with sh ver and sh mem, but both don't seem to be correct.

Hi,allIn my production network, some server is placed behind load-balance devices(array) and a firewall. With sniffer, I found the servers sent many packetw with IP Identification field is 0, Does these packets are correct packets?Thanks!

Hi Experts,Can any body clearly explain about cpu utilization that how we will caliculate and what are points we should look when calculating cpu utlization. Below I am pasting one router cpu utilization.Router1#sh processes cpu history 3222222222...

Is it possible to bind static IP's to particular ports so that any machine that plugs in will be assigned the same IP? How could this be accomplished?--gaurav

I must be having a thick moment. Are all the ports on the 24LC capable of POE but the limitation is that the switch can only support 4 ports due to power max at 60w? Also, is the way to set POE on a port to set the port to an Access Point? The who...

We have a Cisco 2610 router which only handles one T1 right now. We wanted to add a second T1. So we got a new card WIC-1DSU-T1-V2 and plugged that in W1 slot.When I run show diag I can see the card but it does not appear on the running configuration...

Hi everyone I have a few questions about the 1811 router Is it possible to configure the router to use WAN0 for Lan user internet access and WAN1 for wireless user internet? We will be using 2 different internet providers, one being DSL WAN1 and th...

Hi allI'd like to find out how many DRAM memory slots are there on a Cisco 2651XM router and whether they're occupied by a memory module or not. Is there a command available that can do this? I currently have 128MB RAM on this router and is looking a...