Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Dear All,I am having a problem with my GSR 12006 routers. When I insert SFP-OC3-SR modules in my SPA-4xOC3-POS-v2 slots i get the following message:sh ip int | include POSPOS0/0/0 10.124.144.106 YES NVRAM SFP security failure down When I insert th...

Tahir Ali by Level 1
  • 974 Views
  • 2 replies
  • 0 Helpful votes

Hi Folks,I have this network:Clients--RTR1----Net1----RTR2----Web | | |-----Net2-----|In this case net1 and 2 are equal cost paths and thus packets can go via either. If I am SRC IP NAT'ing on RTR2 on the way to the i...

When i enable IP ROUTING on a 4503 i see this in the running-configip routing protocol purge interface.while if i enable IP ROUTING on a 3507 routing it shows IP ROUTING in the running config.although ip routing gets enabled by the above mentioned co...

Hi,I am having a 7206VXR router with NPE-300.To rectify bus error I just replaced the NPE-300 card. But now the router is not booting from flash. The router is hanging while booting and we can manually boot from rommon. What could be the issue ?Thank...

This message pops up on the console of a 7206 router running IOS 12.2(15)T14. I can't find a reference to it on CCO in either the 'output interpretor' or the error message locator.There are no debugs turned on, no special SNMP configs other than the...

jkeeffe by Level 2
  • 2348 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have a 6500 with two sup720's installed they are in an active and standby state.They are both running in a hybrid mode using CatOS cat6000-sup720k8.8-3-6.bin & c6msfc3-psv-mz.122-17d.SXB9.bin on the MSFC3My question is, is there anyway to view t...

Guys,I have a 6500 running with WS-6724-SFP fibre gigabit cardsNow, some interfaces show the input queue (when the port is disabled) as 2000 and when enable at 75 as belowGigabitEthernet1/19 is administratively down, line protocol is down (disabled)...

I want to map out my VOIP network.I want to be able to tell what phone is on what port of my 3560. Is there a way to sort of ask the 3560 "what IP address is attached to you?"Thanks.

hi, when i entred by hyperterminal to verify the SW image, i have find C3750-IPBASE-M ! it's correct? because normaly i find IP Services Image. i want to confirm this if there is somebody who worked with with 3750-TS-E.thank u.

msidahmed by Level 1
  • 1021 Views
  • 5 replies
  • 0 Helpful votes

I've a 3750-E stack with several members, the stack-master has a configured priority of 15.If the master is rebooting another stack-member take over the master role. But i've expected if the old master with it's high priority ist finished with bootin...

ssieger by Level 1
  • 1163 Views
  • 1 replies
  • 0 Helpful votes