Switching

I want to know what are the comands to setup a port on a old CATO's switch with the following information:switchport access vlan XX switchport mode access no cdp enable spanning-tree portfastI can do that on a IOS, but I am strugling on the old syste...

Looking for someone that has a Dell 5224 switch connected to a Cisco switch. Dell engineers have been no help. Dell link to Cisco switch is currently configured with 2 redundant switchport links. Dell side one link forwarding, one discarding. We are ...

HelloCan we apply an access-list to to 2 different L3 interfaces VLAN(198.199)?10XS

Is there a way to find out what is plugged into a switch. I need the IP address, Device type if possible, and port number it is in.I found that the (show arp) will give me a list of IP addresses and mac addresses. But is it the mac addresses of the s...

I have two 6509's using WS-SUP720-BASE (supervisor engine).The ROOT bridge for all our vlans are split across the two switches.Vlans are load balanced over the two switches and each vlan ismonitored through HSRP. For example: - 6509-1 6509-2vlan 10...

What r the commands to b given for configuring STACKING OF 3750 CATALYST SWITCH

Pls help,I need your suggestion to my new network setup specially if the VLAN and VTP is possible. I hve 2811 router and 3 switches.The first 3550 switch (all 48 ports)connected to 2811 via Fastethernet and the 2 cisco switch 2950 via cross cable cab...

Hi. I'm currently looking at purchasing a layer 2 10/100/1000 switch, possibly a 2930G which the Presales dept suggested. My main concern is that the switch be able to shut down a port in the event of a broadcast or multicast storm, or mac flooding...

Hi all. I have two subnets connected by an 1811 router. One is 172.17.0.0/16 the other is 192.168.250.0/24. How can I allow 192.168.250.0 browse Network Places of 172.17.0.0/16 but not allow 172.17 to browse 192.168.250.0?

I need to upgrade 20+ 6500 switches (6506s and 6509s) to SUP32 from SUP1A and don't have physical access to them at this time. I need to verify if these switches have High Speed Fans and would like to know if there is a command I can enter to check t...

Working more on my lab. Running BGP across frame MPLS (two different providers) and EIGRP on internal network; distributing BGP into EIGRP but not the other way around. Works okay except that now, I'd like to have each router advertise itself with e...

Hi, I'm trying to build VLAN on my network using Catalyst 2940. My principal network is 192.168.0.0 255.255.255.0My cisco catalyst is 192.168.0.252I build a VLAN 2 192.168.1.252 255.255.255.0How may I do to allow a PC connected on a VLAN 2 port to ge...

Hi all, if I want to establish vpn tunnels behind my router, to my firewall, can I just port forward the vpn ports to it? and where is the natting done, on the fw or router, also would the firewall be in routed or transparent mode ?