Switching

I notice that many vlan & vtp configuration commands don't appear in the config file for integrated IOS. What's a quick way to see and back up the current vlan & vtp configuration information? Ideally, what I'd like is something like the config file ...

Hello,Is it possible to run NAT inside on a sub interface (int f0/0.100) and not run NAT on another subinteface (int f0/0.101)?

Hello all - I have two 3550's and I have trunking enabled on the fast ethernet ports. I have tried to set both ends to 100/full, however they do not come up. If I go back and set them both to auto/auto they come up. Can I not set trunk ports to 10...

I am reviewing a config file of a 6500-SW and it shows that there are 5 VLANS configued. When I did a show cdp neighbor details, it only showed the default vlan (VLAN1) and no physical links to any other devices. This switch is offsite and I just got...

Hello everyone,I was hoping someone could shed some light on this command for me. I am setting up a syslog server on all the switches ( 3524xl, 3550-48-SMI switches ) and not sure how to use a command. I've set the IP address of the server, set the...

Lets say I have a 48 port Layer 3 switch and I only want to advertise out of one interface (with the ability to add interfaces later; one at a time) and not receive any advertising. What is the easiest way to accomplish this task without advertising...

Hi all, can anyone tell me the latest standards in wireless technology, ie speeds etc

Do I have problems when I'm running on all the switches RSTP (see fig) ? CORE switches are 6500 connected via a channel, 3560 are stacked with yellow cable and one 3560 is connected via fiber to CORE1 and the other 3560 to CORE2CORE1 |===============...

Hi all, can anyone tell me why we have the option to put ports into multiple vlan memberships, ie untagged member of vlan 1 but tagged member of vlan 2

Hi, I have a cisco 1811, I want to have different nat rules based on the external ip trying to reach my public ip.example:ip nat inside source static 10.10.10.1 70.42.21.23 If the external src ip is 99.99.99.99 and ip nat inside source static 10.10....

What does it mean, how to fix it?

We are faced with having to replace all of our Cisco 6500 switches because of end-of-life on all components by 2011. When I replace these devices I will have to provide POE capabilities to support plans to migrate to IP phones. I have taken this into...

I have a problem that appears not to be covered in the troubleshooting docs.i have 3 4507Rs each with 2 Supe V Ten Gig supervisor engines.One one switch both supes display the problems on the other switches one supe shows the same problem.When connec...