Switching

Hi I have tried to read the cisco docs this but it is not as clear as it should be. What exactly is needed to implement this acros the network ? Turn on multicast routing , set pim on interfaces? Does the pim statements go on all interfaces or jus...

Dear All,I am getting received braodcast on my WAN interface. Is there any mechanism available to stop it?I have already tried no ip directed-broadcast and no ip unicast-verify & no ip unreachable. No help.Input queue: 0/75/1/24 (size/max/drops/flush...

Dear community.After using my cisco 2621 as my internet gateway, and upgrading my DSL connection to 20mbit/1mbit, my cpu usage has increased to almost 90%. These 90% are reached when i am downloading @ 15mbit/sec.After issueing a 'show proc cpu sorte...

Hi, i have multiple DSL lines, and doing load balance over all the lines, i.e.route 0.0.0.0 0.0.0.0 Dilaer1route 0.0.0.0 0.0.0.0 Dilaer2and so on,i would like to route SSL traffic to only one dialer, any idea where to start?thank you.

I want to get a lot of information in the diffrence between OSPFv2 and OSPFv3

Nortel has adviced us to set access ports on our 3560 switchs to "mls qos dscp trust." Upon testing, I notice that when I do the "msl qos int status" command, that packets marked dscp 46 show up proberly on the "incoming dscp" field, but in the "outg...

MisterIs possible to configure Queueing (outgoing) and LLQ at the same time , in a port of 4500 Catalyst ???Best Regards

Hi,Does cisco support the in.rdisc protocol from the Solaris OS? If so which ones are the commands.

HiHow much time does it take a server attach to two swith using hp NFT to detect a link failure on the primary link.Let's say the link failure is cause by power been removed from the first swith

Does Cisco offer any good GUI tools that offer up managing Catalyst 3560 switch and other devices?Thanks,Adam

Hi allthis is a basic question, but what defines ethernet, is it the physical medium, or way the frames are constructed etc, also would a ppp serial link be classed as ethernet as the frames travel through it ?

Hi allIf I team a nic on my server and use etherchannel on the switch, will this be ok? do I need to enable or disable spanning tree ?

This modem is connected to Computer that is connected to LAN. And if this computer is turned off, the internet on other computersis disconnected. How can i connect this modem to provide an internet to other computers, even if the Server is off.